5 Vin single output
DC-DC CONVERTERS POLA Non-isolated
For the most current data and application support visit www.artesyn.com/powergroup/products.htm
Part Number System with Options
Point of Load Alliance
V = Vertical
05 = 5 V
01 = 8 A
Mounting Option (9)
D = Horizontal Through-Hole (Matte Sn)
H = Horizontal Through-Hole (Sn/Pb)
A = Through-Hole Std. Pin Length (0.150”)
Output Voltage Code
W = Wide
Output Voltage Adjustment of the PTV05010 Series
The ultra-wide output voltage trim range offers major advantages to users who
select the PTV05010. It is no longer necessary to purchase a variety of
modules in order to cover different output voltages. The output voltage can be
trimmed in a range of 0.8 Vdc to 3.6 Vdc. When the PTV05010 converter
leaves the factory the output has been adjusted to the default voltage of 0.8 V.
1 Remote ON/OFF. Positive logic
ON: Pin 7 open; or V > (Vin - 0.5 V)
Pin 7 GND; or V < 0.6 V
2 See Figure 1 for safe operating curve.
3 A 100 µF electrolytic input capacitor is required for proper operation as
well as a 10F high-frequency ceramic capacitor. The electrolytic -
capacitor must be rated for a minimum of 300 mArms of ripple current.
4 An external output capacitor is not required for basic operation. Adding
100 µF of distributed capacitance at the load will improve the transient
5 1 A/µs load step, 50 to 100% Iomax, C3 = 100 µF.
6 If utilized Vout will track applied voltage by ±0.3 V (up to Vo set point).
7 The pre-bias start-up feature is not compatible with Auto-Track™. This is
because when the module is under Auto-Track™ control, it is fully active
and will sink current if the output voltage is below that of a back-feeding
source. Therefore to ensure a pre-bias hold-off, one of the following two
techniques must be followed when input power is first applied to the
module. The Auto-Track™ function must either be disabled, or the
module’s output held off using the Inhibit pin. Refer to Application Note
195 for more details.
8 The set-point voltage tolerance is affected by the tolerance and stability
of Rset. The stated limit is unconditionally met if Rset has a tolerance of
1% with 100/ºC or better temperature stability.
9 To order Pb-free (RoHS compatible) through-hole parts replace the
mounting option ‘H’ with ‘D’, e.g. PTV05010WAD.
10 NOTICE: Some models do not support all options. Please contact your
local Artesyn representative or use the on-line model number search tool at
http://www.artesyn.com/powergroup/products.htm to find a suitable
EFFICIENCY TABLE (IO = IOmax)
OUTPUT VOLTAGE EFFICIENCY
Vo = 3.3 V
Vo = 2.5 V
Vo = 1.8 V
Vo = 1.5 V
Vo = 1.2 V
Vo = 1.0 V
File Name: ptv05010w.pdf Rev (02): 16 Dec 2005