http://www.datasheet4u.com

900,000+ Datasheet PDF Search and Download

Datasheet4U offers most rated semiconductors datasheets pdf




Freescale Semiconductor Electronic Components Datasheet

MC9S08GW64 Datasheet

Microcontrollers

No Preview Available !

MC9S08GW64 pdf
Freescale Semiconductor
Data Sheet: Technical Data
Document Number: MC9S08GW64
Rev. 3, 1/2011
MC9S08GW64 Series
Covers: MC9S08GW64 and
MC9S08GW6480-LQFP
Case 917A
64-LQFP
Case 840F
14 14
10 10
MC9S08GW32
8-Bit HCS08 Central Processor Unit (CPU)
comparator can be used as hardware breakpoint. Full mode,
Comparator A compares address and Comparator B compares data.
Supports both tag and force breakpoints
– New version of S08 core with same performace as traditional S08 and
lower power
– Up to 20 MHz CPU at 3.6 V to 2.15 V and up to 10 MHz CPU at 3.6 V
to 1.8 V, across temperature range of –40 C to 85 C
– HC08 instruction set with added BGND instruction
– Support for up to 48 interrupt/reset sources
On-Chip Memory
– Flash read/program/erase over full operating voltage and temperature
– Random-access memory (RAM)
– Security circuitry to prevent unauthorized access to RAM and flash
contents
Power-Saving Modes
– Two low power stop modes and reduced power wait mode
– Low power run and wait modes allow peripherals to run while voltage
regulator is in standby
– Peripheral clock gating register can disable clocks to unused modules,
thereby reducing currents
– Very low power external oscillator that can be used in stop2 or stop3
modes to provide accurate clock source to real time counter
– 6 s typical wakeup time from stop3 mode
Clock Source Options
– Oscillator (XOSC1) — Loop-control Pierce oscillator; Crystal or
ceramic resonator of 32.768 kHz; Clock source for iRTC or ICS
– Oscillator (XOSC2) — Loop-control Pierce oscillator; Crystal or
ceramic resonator range of 31.25 kHz to 38.4 kHz or 1 MHz to 16 MHz;
optional clock source for ICS
– Internal Clock Source (ICS) — Internal clock source module
containing a frequency-locked-loop (FLL) controlled by internal or
external reference (XOSC1, XOSC2); precision trimming of internal
reference allows 0.2% resolution and 2% deviation over temperature
and voltage; supporting CPU/bus frequencies from 1 MHz to 20 MHz
System Protection
– Watchdog computer operating properly (COP) reset with option to run
from dedicated 1 kHz internal clock source or bus clock
– Low-voltage warning with interrupt
– Low-voltage detection with reset or interrupt
– Illegal opcode and illegal address detection with reset
– Flash block protection
Development Support
– Single-wire background debug interface
– Breakpoint capability to allow single breakpoint setting during
in-circuit debugging (plus 3 more breakpoints in breakpoint unit)
– Breakpoint (BKPT) debug module containing three comparators (A, B,
and C) with ability to match addresses in 64 KB space. Each
Peripherals
LCD — up to 440 or 836 LCD driver with internal charge pump and
option to provide an internally regulated LCD reference that can be
trimmed for contrast control
ADC16 — two analog-to-digital converters; 16-bit resolution; one
dedicated differential per ADC; up to 16-ch; up to 2.5 s conversion
time for 12-bit mode; automatic compare function; hardware
averaging; calibration registers; temperature sensor; internal bandgap
reference channel; operation in stop3; fully functional from 3.6 V to
1.8 V
PRACMP —three rail to rail programmable reference analog
comparator; up to 8 inputs; on-chip programmable reference generator
output; selectable interrupt on rising, falling, or either edge of
comparator output; operation in stop3
SCI — four full duplex non-return to zero (NRZ); LIN master extended
break generation; LIN slave extended break detection; wakeup on
active edge; SCI0 designed for AMR operation; TxD of SCI1 and SCI2
can be modulated with timers and RxD can recieved through
PRACMP;
SPI— three full-duplex or single-wire bidirectional; double-buffered
transmit and receive; master or slave mode; MSB-first or LSB-first
shifting; SPI0 designed for AMR opeartion
IIC — up to 100 kbps with maximum bus loading; multi-master
operation; programmable slave address; interrupt driven byte-by-byte
data transfer; supporting broadcast mode and 10-bit addressing;
supporting SM BUS functionality; can wake from stop3
FTM — 2-channel flextimer module; selectable input capture, output
compare, or buffered edge- or center-aligned PWM on each channel
IRTC — independent real-time clock, independent power domain, 32
bytes RAM, 32.768 kHz input clock optional output to ICS, hardware
calendar, hardware compensation due to crystal or temperature
characteristics, tamper detection and indicator
PCRC — 16/32 bit programmable cyclic redundancy check for
high-speed CRC calculation
MTIM — two 8-bit and one 16-bit timers; configurable clock inputs
and interrupt generation on overflow
PDB — programmable delay block; optimized for scheduling ADC
conversions
PCNT — position counter; working in stop3 mode without waking
CPU; can be used to generate waveforms like timer
Input/Output
– 57 GPIOs including one output-only pin
– Eight KBI interrupts with selectable polarity
– Hysteresis and configurable pullup device on all input pins;
configurable slew rate and drive strength on all output pins.
Package Options
– 80-pin LQFP, 64-pin LQFP
This document contains information on a product under development. Freescale reserves the
right to change or discontinue this product without notice.
© Freescale Semiconductor, Inc., 2010-2011. All rights reserved.


Freescale Semiconductor Electronic Components Datasheet

MC9S08GW64 Datasheet

Microcontrollers

No Preview Available !

MC9S08GW64 pdf
Table of Contents
1 Devices in the MC9S08GW64 Series. . . . . . . . . . . . . . . . . . . .3
2 Pin Assignments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
3 Electrical Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
3.1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
3.2 Parameter Classification . . . . . . . . . . . . . . . . . . . . . . . .10
3.3 Absolute Maximum Ratings . . . . . . . . . . . . . . . . . . . . .10
3.4 Thermal Characteristics . . . . . . . . . . . . . . . . . . . . . . . .11
3.5 ESD Protection and Latch-Up Immunity . . . . . . . . . . . .12
3.6 DC Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . .13
3.7 Supply Current Characteristics . . . . . . . . . . . . . . . . . . .23
3.8 External Oscillator (XOSCVLP) Characteristics . . . . . .26
3.9 Internal Clock Source (ICS) Characteristics . . . . . . . . .27
3.10 AC Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . .28
3.10.1 Control Timing . . . . . . . . . . . . . . . . . . . . . . . . . 29
3.10.2 Timer (TPM/FTM) Module Timing . . . . . . . . . . 30
3.10.3 SPI Timing . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
3.11 Analog Comparator (PRACMP) Electricals . . . . . . . . . 34
3.12 ADC Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . 34
3.13 VREF Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . 39
3.14 LCD Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . 40
3.15 FLASH Specifications . . . . . . . . . . . . . . . . . . . . . . . . . 40
4 Ordering Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41
4.1 Device Numbering System . . . . . . . . . . . . . . . . . . . . . 41
5 Package Information and Mechanical Drawings . . . . . . . . . . 41
Revision History
To provide the most up-to-date information, the revision of our documents on the World Wide Web will be the most current.
Your printed copy may be an earlier revision. To verify you have the latest information available, refer to:
http://freescale.com/
The following revision history table summarizes changes contained in this document.
Rev Date
Description of Changes
1 5/26/2010 Initial public release
2 10/29/2010 Completed all the TBDs.
Updated the voltage output data in the Table 20.
Changed the classification marking of |IInT| to C in the Table 8.
3 1/28/2011 Updated Table 7.
Related Documentation
Find the most current versions of all documents at: http://www.freescale.com
Reference Manual
(MC9S08GW64RM)
Contains extensive product information including modes of operation, memory,
resets and interrupts, register definition, port pins, CPU, and all module
information.
MC9S08GW64 Series MCU Data Sheet, Rev. 3
2 Freescale Semiconductor


Part Number MC9S08GW64
Description Microcontrollers
Maker Freescale Semiconductor
Total Page 30 Pages
PDF Download
MC9S08GW64 pdf
Download PDF File
[partsNo] view html
View PDF for Mobile






Related Datasheet

1 MC9S08GW64 8-Bit CPU Motorola Semiconductor
Motorola Semiconductor
MC9S08GW64 pdf
2 MC9S08GW64 Microcontrollers Reference Manual Freescale Semiconductor
Freescale Semiconductor
MC9S08GW64 pdf
3 MC9S08GW64 Microcontrollers Freescale Semiconductor
Freescale Semiconductor
MC9S08GW64 pdf






Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

site map

webmaste! click here

contact us

Buy Components