Capacitor Ordering Information
C 0201 C 101
C - Ceramic
See dimension table
C - Standard
Capacitance Code, pF
First two digits represent significant figures.
Third digit specifies number of zeros. 100 pF = 101.
(Use “9” for 1.0 through 9.9 pF)
(Use “8” for 0.1 through .99 pF)
D = ± 0.5pF J = ± 5% K = ± 10% M = ±20%
3 G AC
C = Standard (Tin-plate
Failure Rate Level
A = Not Applicable
Designated by Capacitance
Change Over Temperature Range
G = C0G (0±30 ppm/°C) (-55°C +125°C)
3 = 25V
As detailed in the KEMET Surface Mount Catalog F3102 for C0G, with following specific requirements
based on room temperature (25°C) parameters:
• Operating Range: -55°C to +125°C, with no-bias capacitance shift limited to ± 30 ppm/°C over that range.
• Insulation Resistance (IR) measured after 2 minutes at rated voltage @ 25°C: Limit is 10,000 MΩ, minimum.
• Capacitance and Quality Factor (Q) measured at 1 MHz and 0.5 Vrms: DF limit is 0.1%
Q = (< 30 pF: Q ≥ 400 + 20C; > 30pF: Q ≥ 1000)
C = Nominal Capacitance
These components are suitable for reflow only. All parts incorporate the standard KEMET barrier layer of pure
nickel, with an overplate of pure tin to provide excellent solderability as well as resistance to leaching.
These chips will be supplied unmarked.
In general, the information in the KEMET Surface Mount catalog F3102 applies to these
capacitors. The information in this bulletin supplements that in the catalog.
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com