Absolute Maximum Ratings (Ta=25°C)
Forward current derating (Ta ≥ 85°C)
Peak transient forward current (Note 1)
Output power dissipation
Operating temperature range
Storage temperature range
Lead solder temperature(10 s)
(AC,1 min.,R.H.≤ 60%,Ta=25°C)
ΔIF / ΔTa
-40 to 100
Tstg -55 to 125
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even
if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Recommended Operating Conditions
Min Typ. Max Unit
Input current , ON
Input voltage , OFF
— 18 mA
4.5 5.0 5.5
Topr -40 — 100 °C
Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the
device. Additionally, each item is an independent guideline respectively. In developing designs using this
product, please confirm specified characteristics shown in this document.
Correlation between Input current, switching speed and drive circuit
Typical switching speed
21 – 23 MBd
18 – 20 MBd
(Page 4, With Speed up capacitor)
23 – 27 MBd
Note 1 : Pulse width PW ≤ 1μs, 300 pps.
Note 2 : This device is regarded as a two terminal device : pins 1 and 3 are shorted together, as are pins 4,5 and 6.
Note 3 : The detector of this product requires a power supply voltage (VCC) of 4.5 V or higher for stable operation.
If the VCC is lower than this value, an ICC may increase, or an output may be unstable.
Be sure to use the product after checking the supply current, and the operation of a power-on/-off.
Free Datasheet http://www.datasheet4u.com/