25020AN Datasheet | Atmel

Features - Serial Peripheral Interface (SPI) patible - Supports SPI Modes 0 (0,0) and 3 (1,1) - Data Sheet Describes Mode 0 Operation - Medium-voltage and Standard-voltage Operation - 2.7 (VCC = 2.7V to 5.5V) Extended Temperature Range - 40°C to +125°C 5.0 MHz Clock Rate 8-byte Page Mode Block Write Protection - Protect 1/4, 1/2, or Entire Array - Write Protect (WP) Pin and Write Disable Instructions for Both Hardware and Software Data Protection - Self-timed Write Cycle (10 ms max) .. - High Reliability - Endurance: One Million Write Cycles - Data Retention: 100 Years - 8-lead PDIP, 8-lead JEDEC SOIC, 8-lead TSSOP Packages - - - - SPI Serial Extended Temperature EEPROMs 1K (128 x 8) 2K (256 x 8) 4K (512 x 8) Description The AT25010A/020A/040A provides 1024/2048/4096 bits of serial electrically-erasable programmable read-only memory (EEPROM) organized as 128/256/512 words of 8 bits each. The device is optimized for use in many automotive applications where low-power and low-voltage operation are essential. The AT25010A/020A/040A is available in space-saving 8-pin PDIP, 8-lead JEDEC SOIC and 8-lead TSSOP packages. The AT25010A/020A/040A is enabled through the Chip Select pin (CS) and accessed via a three-wire interface consisting of Serial Data Input (SI), Serial Data Output (SO), and Serial Clock (SCK). All programming cycles are pletely self-timed, and no separate erase cycle is required before write. Block write protection is enabled by programming the status register with one of four blocks of write protection. Separate program enable and program disable instructions are provided for additional data protection. Hardware data protection is provided via the WP pin to protect against inadvertent write attempts. The HOLD pin may be used to suspend any serial munication without resetting the serial sequence. Table 1. Pin Configurations Pin Name CS SCK SI SO GND VCC WP HOLD Function Chip Select Serial Data Clock Serial Data Input Serial...