Datasheet4U Logo Datasheet4U.com

8283 - LNB SUPPLY AND CONTROL-VOLTAGE REGULATOR

General Description

The ENT (Tone Enable) terminal activates the internal tone signal, modulating the dc output with a ±0.3 V, 22 kHz symmetrical waveform.

The internal oscillator is factory-trimmed to provide a tone of 22 kHz ±2 kHz.

No further adjustment is required.

Key Features

  • I I I I I I I I I I Short-Circuit Protected Bypass Function for Slave Operation LNB Selection and Stand-By Function Built-In Tone Oscillator Factory Trimmed to 22 kHz, Facilitates DiSEqC™ (a trademark of.

📥 Download Datasheet

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
8283 PRELIMINARY INFORMATION (Subject to change without notice) November 21, 2000 LNB SUPPLY AND CONTROL-VOLTAGE REGULATOR Intended for analog and digital satellite receivers, the low-noise block converter regulator (LNBR) is a monolithic linear and switching voltage regulator designed to provide power and interface signals to the LNB down converter via the coaxial cable. If the device is in stand-by mode (EN terminal LOW), the regulator output is disabled, allowing the antenna downconverters to be supplied or controlled by other satellite receivers sharing the same coaxial cable. Similar two-output LNB supply and control voltage regulators are the A8284SB/SLB.