PRELIMINARY TECHNICAL DATA
= 16-/32- Channel, 3.5 Ω
1.8 V to 5.5 V, ±2.5 V, Analog Multiplexers
Preliminary Technical Data
1.8 V to 5.5 V Single Supply
±2.5 V Dual Supply Operation
3.5 Ω On Resistance
0.5 Ω On Resistance Flatness
Rail to Rail Operation
30ns Switching Times
Single 32 to 1 Channel Multiplexer
Dual/Differential 16 to 1 Channel Multiplexer
TTL/CMOS Compatible Inputs
For Functionally Equivalent devices with Serial Interface
Data Acquisition Systems
Audio and Video Switching
Battery Powered Systems
Automatic Test Equipment
FUNCTIONAL BLOCK DIAGRAMS
1 OF 32
1 OF 16
A0 A1 A2 A3 A4 EN
A0 A1 A2 A3 EN
The ADG726/ADG732 are monolithic CMOS 32
channel/dual 16 channel analog multiplexers. The
ADG732 switches one of thirty-two inputs (S1-S32) to a
common output, D, as determined by the 5-bit binary
address lines A0, A1, A2, A3 and A4. The ADG726
switches one of sixteen inputs as determined by the four
bit binary address lines, A0, A1, A2 and A3.
On chip latches facilitate microprocessor interfacing. The
ADG726 device may also be configured for differential
operation by tying CSA and CSB together. An EN input
is used to enable or disable the devices. When disabled, all
channels are switched OFF.
These multiplexers are designed on an enhanced submi-
cron process that provides low power dissipation yet gives
high switching speed, very low on resistance and leakage
currents. They operate from single supply of 1.8V to 5.5V
and ±2.5 V dual supply, making them ideally suited to a
variety of applications. On resistance is in the region of a
few Ohms and is closely matched between switches and
very flat over the full signal range. These parts can operate
equally well as either Multiplexers or De-Multiplexers
and have an input signal range which extends to the sup-
plies. In the OFF condition, signal levels up to the
supplies are blocked. All channels exhibit break before
make switching action preventing momentary shorting
when switching channels.
They are available in either 48 lead LFCSP or TQFP
1. +1.8 V to +5.5 V Single or ±2.5 V Dual Supply
operation. These parts are specified and guaranteed
with +5 V ±10%, +3 V ±10% single supply and
±2.5 V ±10% dual supply rails.
2. On Resistance of 3.5 Ω.
3. Guaranteed Break-Before-Make Switching Action.
4. 7mm x 7mm 48 lead LF Chip Scale Package (CSP)
or 48 lead TQFP package.
REV. PrD 2001
Information furnished by Analog Devices is believed to be accurate and
reliable. However, no responsibility is assumed by Analog Devices for its
use, nor for any infringements of patents or other rights of third parties
which may result from its use. No license is granted by implication or
otherwise under any patent or patent rights of Analog Devices.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
World Wide Web Site: http://www.analog.com
Analog Devices, Inc., 2001