ADN4693E-1 Datasheet | Analog Devices

FEATURES - Full-duplex M-LVDS transceiver (driver and receiver pair) - Switching rate: 200 Mbps (100 MHz) - Type 1 receiver with input hysteresis of 25 m V - patible with the TIA/EIA-899 standard for M-LVDS - Glitch free power-up/power-down on M-LVDS bus - Controlled transition times on driver output - mon-mode range: - 1 V to +3.4 V, allowing munication with 2 V of ground noise - Driver outputs high-Z when disabled or powered off - Enhanced ESD protection on bus pins - ≥±15 k V HBM, air discharge - ≥±8 k V HBM, contact discharge - ≥±10 k V IEC 61000-4-2, air discharge - ≥±8 k V IEC 61000-4-2, contact discharge - Operating junction temperature range: - 40°C to +120°C - 16-lead, 4 mm × 4 mm LFCSP APPLICATIONS - Backplane and cable multipoint data transmission - Multipoint clock distribution - Low power, high speed alternative to shorter RS-485 links - Networking and wireless base station infrastructure - Grid infrastructure and relay protection systems FUNCTIONAL BLOCK DIAGRAM Figure 1. GENERAL DESCRIPTION The ADN4693E-1 is a multipoint, low voltage differential signaling (M-LVDS) transceiver (driver and receiver pair) that can operate at up to 200 Mbps (100 MHz) nonreturn to zero (NRZ). The receiver detects the bus state with a differential input of as little as ±50 m V over the mon-mode voltage range of the device. Electrostatic discharge (ESD) protection of up to ±15 k V is implemented on the bus pins. The ADN4693E-1 is designed to the TIA/EIA-899 standard for use in M-LVDS networks and plements TIA/EIA-644 LVDS devices with additional multipoint capabilities. The ADN4693E-1 features a Type 1 receiver with 25 m V of hysteresis so that slow-changing signals or loss of input does not lead to output oscillations. This full-duplex device is available in a pact 16-lead, 4 mm × 4 mm lead frame chip scale package (LFCSP). The ADN4693E-1 is specified over the - 40°C to +120°C junction temperature range. Rev. 0 DOCUMENT FEEDBACK TECHNICAL SUPPORT Information furnished by Analog...