TISP70XXL1
TISP70XXL1 is TRIPLE ELEMENT THYRISTOR OVERVOLTAGE PROTECTORS manufactured by Bourns.
Description
The TISP70xx L1 series are 3-point overvoltage protectors designed for protecting against metallic (transverse mode) and simultaneous longitudinal (mon mode) impulses. Each terminal pair has the same voltage limiting values and surge current capability. These devices are designed to limit overvoltages between signal, data and control port conductors, connected to terminals T1 and T2, and a protective ground, G. Each terminal pair has a symmetrical voltage-triggered bidirectional thyristor characteristic (Figure 1). Overvoltages are initially clipped by breakdown clamping until the voltage rises to the breakover level, which causes the device to crowbar into a low-voltage on state. This low-voltage on state causes the current resulting from the overvoltage to be safely diverted through the device. The device holding current will normally be higher than the available short circuit d.c. system current, causing the protector to switch off as the diverted current subsides.
How To Order
For Standard Termination Finish Order As
TISP7015L1DR TISP7015L1D TISP7038L1DR TISP7038L1D
Device TISP7015L1
Package D (8-pin, Small-outline)
Carrier R (Embossed Tape Reeled) Tube R (Embossed Tape Reeled) Tube
For Lead Free Termination Finish Order As
TISP7015L1DR-S TISP7015L1D-S TISP7038L1DR-S TISP7038L1D-S
TISP7038L1
D (8-pin, Small-outline)
- Ro HS Directive 2002/95/EC Jan 27 2003 including Annex JULY 2000
- REVISED FEBRUARY 2005 Specifications are subject to change without notice. Customers should verify actual device performance in their specific applications.
Data Sheet 4 U .
..
TISP70xx L1 (VLV) Overvoltage Protectors
The TISP70xx L1 is guaranteed to withstand the listed international ESD (Electro Static Discharge), and...
