Datasheet4U Logo Datasheet4U.com

UP62-80 - (UP62-x0) Solid State Relays

Description

The temperature limit switch is a readily available accessory.

It is a thermostat especially designed for overheat protection for small assemblies.

The thermal response is excellent due to its miniaturized housing.

📥 Download Datasheet

Datasheet preview – UP62-80

Datasheet Details

Part number UP62-80
Manufacturer Carlo Gavazzi
File Size 50.81 KB
Description (UP62-x0) Solid State Relays
Datasheet download datasheet UP62-80 Datasheet
Additional preview pages of the UP62-80 datasheet.

📁 Similar Datasheet

  • uP6201A - Compact Dual-Phase Synchronous-Rectified Buck Controller (uPI Semiconductor)
  • uP6201B - Compact Dual-Phase Synchronous-Rectified Buck Controller (uPI Semiconductor)
  • UP6202 - 150mA Low Power CMOS LDO (UniverChipSemi)
  • uP6203 - Compact Dual-Phase Synchronous-Rectified Buck Controller (uPI Semiconductor)
  • uP6204 - Compact Three-Phase Synchronous-Rectified Buck Controller (uPI Semiconductor)
  • UP6205 - Compact Dual-Phase Synchronous-Rectified Buck Controller (uPI Semiconductor)
  • UP6206 - 300mA Low Power CMOS LDO (UniverChipSemi)
  • uP6207 - 3 Phase Synchronous-Rectified Buck Contronller (uPI Semiconductor)
  • uP6208 - 12 Phase Synchronous-Rectified Buck Controller (uPI Semiconductor)
  • uP6209 - Compact Dual-Phase Synchronous-Rectified Buck Controller (uPI Semiconductor)
Other Datasheets by Carlo Gavazzi
  • UP62-70 - (UP62-x0) Solid State Relays
  • UP62-90 - (UP62-x0) Solid State Relays

Full PDF Text Transcription

Click to expand full text
www.DataSheet4U.com Solid State Relays Accessories.POWER Type UP 62 - .. • Temperature limit switch for overheat protection of small assemblies. Product Description The temperature limit switch is a readily available accessory. It is a thermostat especially designed for overheat protection for small assemblies. The thermal response is excellent due to its miniaturized housing. It becomes an effective thermal cutout due to the fact that this limit switch can be fitted close to the heatsink of the relay. When connected serial with the control voltage, the TLS will switch off the relay as soon as the operating temperature of the switch is reached. The relay will be activated again when the temperature drops (approx. 30°C) below its cutout value.
Published: |