Datasheet4U Logo Datasheet4U.com

AP3127B - Step-Up DC/DC Converter

Description

The AP3127B Series is a fixed frequency, constant current step-up DC/DC converter ideal for driving LEDs used in backlighting applications on cellular phones, PDAs and digital cameras etc.

Features

  • z Input voltage range : 2.5V-6V z Output voltage range : up to 23V externally set-up reference voltage 0.25V　　 z Oscillation frequency : 1.0MHz　 z On resistance : 0.8Ω z Efficiency : 88%(When driving 3 white LEDs in series Vin=3.6V ILED=20mA) z Control : PWM control z Stand-by Current : ISTB=1.0uA z Load capacitor : 0.22uF,ceramic z Lx limit Current :1.0A Package S0T-23-6L Typical.

📥 Download Datasheet

Datasheet Details

Part number AP3127B
Manufacturer Chipown
File Size 433.07 KB
Description Step-Up DC/DC Converter
Datasheet download datasheet AP3127B Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
AP3127 GREEN MODE PWM CONTROLLER Diodes
AP3127H GREEN MODE PWM CONTROLLER Diodes
AP3120 TRANSFORMERS apx
AP3125A GREEN MODE PWM CONTROLLER Diodes
AP3125B GREEN MODE PWM CONTROLLER Diodes

Other Datasheets by Chipown

Part Number Description
AP3127 PWM DC-DC
AP3130 High Performance Asynchronies Boost

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
AP3127B Chipown Step-Up DC/DC Converter Series White LED Backlight Driver General Description The AP3127B Series is a fixed frequency, constant current step-up DC/DC converter ideal for driving LEDs used in backlighting applications on cellular phones, PDAs and digital cameras etc. Output voltage of up to 23V can be derived, and from a 3.2V input six white LED’s can be driven in series or alternatively, using a 2.5V input, a network of two parallel legs with three in each may be driven. Luminance of the LED’s is controlled by changing the duty cycle of a PWM signal applied to the CE pin. In addition, an internal MOSFET with an Rds(on) of 0.8Ω is used. Allow profile and small board area solution can be achieved using a chip coil and an ultra small ceramic output capacitor (CL) of 0.22uF.
Published: |