Datasheet4U Logo Datasheet4U.com

EM6420 - Ultra Low Power Capacitive Touch-Sensor Interface

Description

The EM6420 is an ultra low power Touch Sensor Interface IC able to scan sequentially up to 16 capacitive sensors.

Features

  • Up to 16 analogue sensor inputs.
  • User selectable communication interfaces: 4-wire SPI, I2C, 4-bit parallel interface and 8-bit direct output.
  • User-selectable active edge IRQ output signal.
  • Active high enable input.
  • No software development and tuning required.
  • Development tools and documentations available.
  • Complete touch module available: IC + electrodes design on various non-conductive substrates Electrical Characteristics.

📥 Download Datasheet

Datasheet Details

Part number EM6420
Manufacturer EM Microelectronic
File Size 1.28 MB
Description Ultra Low Power Capacitive Touch-Sensor Interface
Datasheet download datasheet EM6420 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
EM640FP16 256K x16 bit Low Power and Low Voltage Full CMOS Static RAM Emerging Memory & Logic Solutions
EM640FP8 512K x8 bit Super Low Power and Low Voltage Full CMOS Static RAM Emerging Memory & Logic Solutions
EM640FU16E 256K x16 bit Super Low Power and Low Voltage Full CMOS Static RAM Emerging Memory & Logic Solutions
EM640FU16E 256K x 16 bit Super Low Power and Low Voltage Full CMOS Static RAM Emerging Memory & Logic Solutions
EM640FU8E 512K x8 bit Super Low Power and Low Voltage Full CMOS Static RAM Emerging Memory & Logic Solutions

Other Datasheets by EM Microelectronic

Part Number Description
EM6415 Sensor Signal Conditioner Circuit
EM603002 DTCXO Temperature Compensated RealTime Clock/Calendar
EM6110 Universal LCD Controller
EM6121 LCD Controller and Driver Character Generator ROM and RAM inside
EM6124 Digitally Programmable 8 to 25 Multiplex LCD Controller & Driver

Full PDF Text Transcription

Click to expand full text
DATASHEET Ɩ EM6420-DS-02 Ultra Low Power Capacitive Touch Sensor Interface IC Description The EM6420 is an ultra low power Touch Sensor Interface IC able to scan sequentially up to 16 capacitive sensors. The device parameters (number of used sensors, sensors scan frequency, sensors sensitivity level, IRQ condition) are configurable either from a host microcontroller through a communication port or through configuration inputs. Recognised touch inputs will be signaled with an active edge at the IRQ pad and data are ready to be read through the communicaion port by the host MCU. Conditions for the IRQ to get active are configurable : at the end of every scan, at the end of a scan if at least one sensor is active or at the end of a scan if the sensors state has changed.
Published: |