B82111B Datasheet | EPCOS

Features - High resonant frequency - High rated current - Ro HS-patible1) Applications - RF blocking and filtering - Interference suppression in small appliances Marking LR and IR in clear text and approval mark Delivery mode Bulk Approvals Approval mark Standard EN 60938-2 Dimensional drawing 102-5 1 2 SSB0090-A 1) Ro HS-patible is defined as patible with the following documents: DIRECTIVE 2002/95/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 13 February 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment (2004) 606 final Proposal for a COUNCIL DECISION amending Directive 2002/95/EC of the European Parliament and of the Council for the purposes of establishing the maximum concentration values for certain hazardous substances in electrical and electronic equipment. Please read the Important notes at the end of this document. 11/05 VHF chokes Ferrite core General technical data Test voltage Vtest Rated inductance LR Inductance tolerance Rated current IR Inductance decrease ΔL/L0 DC resistance Rtyp Resonance frequency fres, min Climatic category (IEC 60068-1) Current derating Iop/IR versus ambient temperature TA (rated temperature TR = 60 °C) 2500 VAC, 1 min Measuring frequency:L ≤ 10 μH = 1 MHz 10 μH < L ≤ 1000 μH = 100 k Hz ±20% Referred to 60 °C ambient temperature, for derating see below ≤10% (referred to initial value) at DC load IR at 20 °C Typical value, measured at 20 °C ambient temperature Typical value, measured with Scalar Network Analyzer ZAS from Rohde & Schwarz 55/125/56 (- 55 °C/+125 °C/56 days damp heat test) 1.2 I op IR SSB0087-Q-E ˚C 140 TA Mounting information When bending the leads, take care that the bending point is at least 3 mm apart from the face ends of the core and that the start-of-winding-areas are not subjected to any mechanical stress. Please read the Important notes at the end of this...