Note: Below is a high-fidelity text extraction (approx. 800 characters) for
SRF01. For precise diagrams, and layout, please refer to the original PDF.
SRF01 Ultrasonic range finder Technical Documentation Overview The SRF01 is a single transducer ultrasonic rangefinder in a very small footprint PCB. Connection is to a s...
View more extracted text
asonic rangefinder in a very small footprint PCB. Connection is to a single pin Serial interface. The serial interface is a standard TTL level UART format of 1 start, 1 stop and no parity bits, and may be connected directly to many controllers, such as the Basic Stamps or the PICAXE. Baud rate at power-up is always 9600, there is a command to change this to 19200 or 38400 baud if preferred. Up to 16 SRF01's may be connected together on a single bus. Like all our rangefinders, the SRF01 can measure in Cm or Inches. Power Requirements The SRF01 accepts any voltage between 3.3v and 12v, however the recommended maximum is 5.5v
SRF01 Datasheet
