5 Vin single output
DC-DC CONVERTERS POLA Non-isolated
For the most current data and application support visit www.artesyn.com/powergroup/products.htm
±10 mV ±12 mV
Part Number System with Options
Point of Load Alliance
05 = 5 V
03 = 30 A
No Suffix = Trays
T = Tape and Reel (8)
Mounting Option (9)
D = Horizontal Through-Hole (Matte Sn)
H = Horizontal Through-Hole (Sn/Pb)
S = Surface-Mount (63/37 Sn/Pb
pin solder material)
Z = Surface-Mount (96.5/3.0/0.5 Sn/Ag/Cu
pin solder material)
A = Through-Hole Std. Pin Length (0.140”)
A = Surface-Mount Tin/Lead Solder Ball
Output Voltage Code
W = Wide
Output Voltage Adjustment of the PTH05030 Series
The ultra-wide output voltage trim range offers major advantages to users who
select the PTH05030. It is no longer necessary to purchase a variety of
modules in order to cover different output voltages. The output voltage can be
trimmed in a range of 0.8 Vdc to 3.6 Vdc. When the PTH05030 converter
leaves the factory the output has been adjusted to the default voltage of 0.8 V.
1 Remote ON/OFF. Positive Logic
ON: Pin 4 open; or V > Vin - 0.5 V
Pin 4 GND; or V < 0.8 V (min - 0.2 V).
2 See Figure 1 for safe operating curve.
3 A 1,500 µF electrolytic input capacitor is required for proper operation.
The capacitor must be rated for a minimum of 900 mA rms of ripple
4 An external output capacitor is not required for basic operation. Adding
330 µF of distributed capacitance at the load will improve the transient
5 1 A/µs load step, 50 to 100% Iomax, Cout = 330 µF.
6 If utilized Vout will track applied voltage by ±0.3 V (up to Vo set point).
7 The pre-bias start-up feature is not compatible with Auto-Track™. This is
because when the module is under Auto-Track™ control, it is fully active
and will sink current if the output voltage is below that of a back-feeding
source. Therefore to ensure a pre-bias hold-off, one of the following two
techniques must be followed when input power is first applied to the
module. The Auto-Track™ function must either be disabled, or the
module’s output held off using the Inhibit pin. Refer to Application Note
157 for more details.
8 Tape and reel packaging only available on the surface-mount versions.
9 To order Pb-free (RoHS compatible) surface-mount parts replace the
mounting option ‘S’ with ‘Z’, e.g. PTH05030WAZ. To order Pb-free
(RoHS compatible) through-hole parts replace the mounting option ‘H’
with ‘D’, e.g. PTH05030WAD.
10 NOTICE: Some models do not support all options. Please contact your
local Artesyn representative or use the on-line model number search tool at
http://www.artesyn.com/powergroup/products.htm to find a suitable
EFFICIENCY TABLE (IO = 20 A)
OUTPUT VOLTAGE EFFICIENCY
Vo = 1.0 V
Vo = 1.2 V
Vo = 1.5 V
Vo = 1.8 V
Vo = 2.0 V
Vo = 2.5 V
Vo = 3.3 V
File Name: pth05030.pdf Rev (07): 16 Dec 2005