900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






Emerson

SIL15-12SADJ-V3J Datasheet Preview

SIL15-12SADJ-V3J Datasheet

DC-DC / Non-Isolated

No Preview Available !

SIL15 Series
Single output
DC/DC CONVERTERS 15A Non-Isolated DC/DC Converters
Ultra-wide trim range (0.9V to 3.3V/5V)
Current sink capable for termination applications
Horizontal and vertical models available
High power density design means reduced board space
requirement
Power good output signal (open collector)
Operating ambient temperature up to +80ºC with suitable
derating and forced air cooling
Remote ON/OFF (active high)
0A minimum load
Input undervoltage lockout
Over-current and short-circuit protection
The SIL15 Series is a new high density open frame non-isolated converter for space-
sensitive applications. Each model has a wide input range (4.5V to 5.5V or 10.2V to
13.8V) and offer a wide 0.9V to 3.3V/5V output voltage range with a 15A load. An external
resistor adjusts the output voltage from its pre-set value of 0.9V to any value up to the
maximum allowed value for that model. Typical efficiencies are 89% for the 5V input
version and 91% for the 12V input version. The SIL15 series offers remote ON/OFF and
over-current protection as standard. With full international safety approval including
EN60950 and UL/cUL60950, the SIL15 reduces compliance costs and time to market.
All specifications are typical at nominal input, full load at 25°C unless otherwise stated
1
NEW Product
2 YEAR WARRANTY
SPECIFICATIONS
OUTPUT SPECIFICATIONS
Voltage adjustability
(See Note 5)
5V input models
12V input models
0.9V to 3.3V
0.9V to 5.0V
Output setpoint accuracy With 1.0% trim resistors
±2.5%
Line regulation
Low line to high line
±0.2% max.
Load regulation
Full load to min. load
±0.5% max.
Min/max load
0A/15A
Overshoot
(at turn on)
5V input models
12V input models
3% max.
1% max.
Undershoot
100mV max.
Ripple and noise
5Hz to 20MHz
(See Note 1)
See table
Transient response
(See Note 2)
Deviation
100mV
200µs recovery to
within regulation band
INPUT SPECIFICATIONS
Input voltage range
5V input model
12V input model
Input current
Minimum load
Remote OFF
Input current (max.)
(See Note 3)
5V input model
12V input model
Input reflected ripple
(See Note 4)
5V input model
12V input model
Remote ON/OFF
Logic compatibility
ON
OFF
Start-up time
(See Note 9)
Power up
Remote ON/OFF
4.5 to 5.5VDC
10.2 to 13.8VDC
65mA
20mA
11.5A @ Io max.
8.1A @ Io max.
200mA (pk-pk)
200mA (pk-pk)
Active high
>2.4VDC
<0.8VDC
<20ms
<20ms
INPUT SPECIFICATIONS Contd.
Turn ON threshold
Turn OFF threshold
5V input model
12V input model
5V input model
12V input model
4.5V
9.0V
4.3V
7.5V
GENERAL SPECIFICATIONS
Efficiency
See table
Switching frequency
Fixed
200kHz typ.
Approvals and
standards (See Note 7)
TÜV Product Service
IEC60950, UL/cUL60950
Material flammability
UL94V-0
Weight
14.2g (0.5oz)
MTBF
Representative model:
MIL-HDBK-217F
468,803 hours
12V model @ 40ºC
100% load, ground benign
Bellcore 332
7,817,294 hours
ENVIRONMENTAL SPECIFICATIONS
Thermal performance
(See Note 10)
Operating ambient,
temperature
Non-operating
Altitude derating
(above sea level)
3,000m (9,843 ft.)
10,000m (32,808 ft.)
0°C to +80°C
-40°C to +125°C
20%
50%
International Safety Standard Approvals
TÜV
UL/cUL CAN/CSA 22.2 No. E139421
UL60950 file No. E139421
TÜV Product Service (EN60950) Certificate No. B0211 19870 205
CB report and certificate to IEC60950
File Name: SIL15.PDF Rev: 31 Jan 2003




Emerson

SIL15-12SADJ-V3J Datasheet Preview

SIL15-12SADJ-V3J Datasheet

DC-DC / Non-Isolated

No Preview Available !

SIL15 Series
Single output
DC/DC CONVERTERS 15A Non-Isolated DC/DC Converters
For the most current data and application support visit www.artesyn.com/powergroup/products.htm
2
NEW Product
OUTPUT
POWER
(MAX.)
INPUT
VOLTAGE
50W 4.5 - 5.5VDC
75W 10.2 - 13.8VDC
OVP
N/A
N/A
OUTPUT
OUTPUT CURRENT
VOLTAGE (12) (MIN.)
0.9V - 3.3V
0A
0.9V - 5.0V
0A
OUTPUT
CURRENT
(MAX.)
15A
15A
EFFICIENCY
(TYP.)
89%
91%
REGULATION
LINE LOAD
±0.2%
±0.2%
±0.5%
±0.5%
MODEL
NUMBER (8)
SIL15-05SADJ-V
SIL15-12SADJ-V
Notes
1 Measured as per recommended set-up. Cin = 270µF (20mΩ esr max,
Cout = 680µF (10mΩ esr max).
2 di/dt = 10A/µs, Vin = Nom, Tc = 25°C, load change = 0.50 lo max. to
0.75 lo max. and 0.75 lo max. to 0.50 lo max.
3 External input fusing is recommended.
4 Measured with external filter. See Application Note 131 for details.
5 Uses external resistor from trim pin to output ground. Min value = 485Ω
for 5V model, 280Ω for 12V model. See Application Note 131 for details.
6 Signal line assumed <3m in length
7 This product is only for inclusion by professional installers within other
equipment and must not be operated as a stand alone product.
8 The standard unit with the suffix '-V' is for vertical mounting. To order a
unit with horizontal mounting, please add the suffix '-H' to the model
number, e.g. SIL15-05SADJ-H.
9 Power-up is the time from application of DC input to Power Good
enabled. Remote ON/OFF is from ON/OFF asserted high to power good
enabled.
10 See Application Note 131 for operation above 50ºC.
11 See Application Note 131 for ripple current requirements.
12 These models have a wide trim output. 5Vin has an output of 0.9V to
3.3V and 12 Vin has an output of 0.9V to 5V. An external resistor adjusts
the output voltage.
Ripple and Noise Specification
Model
5V input models
12V input models
Output
Voltage
0.9 to 2.5V
3.3V
0.9 to 2.5V
3.3V to 5V
Pk - Pk
30mV
40mV
50mV
50mV
RMS
15mV
15mV
20mV
20mV
PROTECTION
Short-circuit protection
Hiccup, non-latching
RECOMMENDED SYSTEM CAPACITANCE
Input capacitance
(See Note 11) 270µF/20mΩ esr max.
Output capacitance (See Note 11) 680µF/10mΩ esr max.
PIN CONNECTIONS
PIN NUMBER
FUNCTION
1 Vout
2 Vout
3 Vout
4 Trim
5 Remote ON/OFF
6 Power Good
7 Ground
8 Ground
9 Reserved
10 Vin
11 Vin
12 Mechanical support
(horizontal version only)
13 Mechanical support
(horizontal version only)
CAUTION: High internal temperatures. Ensure that unit is not user
accessible.
File Name: SIL15.PDF Rev: 31 Jan 2003


Part Number SIL15-12SADJ-V3J
Description DC-DC / Non-Isolated
Maker Emerson
Total Page 3 Pages
PDF Download

SIL15-12SADJ-V3J Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 SIL15-12SADJ-V3J DC-DC / Non-Isolated
Emerson
2 SIL15-12SADJ-V3Y DC-DC / Non-Isolated
Emerson





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy