FT2232HP/FT2233HP Datasheet Datasheet
Document No.: FT_001474 Clearance No.: FTDI#556
Future Technology Devices
(High Speed USB Bridge with Type-C/PD3.0
The FT2233HP/FT2232HP is a Hi-Speed USB device
with a Type-C/PD 3.0 controller that fully supports
the latest USB Type-C and Power Delivery (PD)
standards enabling support for power negotiation
with the ability to sink or source current to a USB
host device. The USB bridge function delivers 2
independent channels compatible with the FT2232H
– Dual Hi-speed USB to multipurpose UART/MPSSE
The FT2233HP/FT2232HP has the following
Support PD specification Rev 3.0.
Port 1 mode configuration for Sink or Dual-role
Port 2 works as Sink, supporting charge
through to port1 (FT2233HPQ and FT2233HPL
Support 5V3A, 9V3A, 12V3A, 15V3A and 20V3A
PDOs as sink or source Type-C/PD Physical
PD policy engine using 32-bit RISC controller
with 8kB data RAM and 48kB code ROM
PD mode configuration through external
Options to use external MCU controlling PD
policy through I2C interface
USB to dual serial ports with a variety of
Entire USB protocol handled on the chip. No
USB specific firmware programming required.
USB 2.0 High Speed (480Mbits/Second) and
Full Speed (12Mbits/Second) compatible.
Two Multi-Protocol Synchronous Serial Engine
(MPSSE) on channel A and channel B, to
simplify synchronous serial protocol (USB to
JTAG, I2C, SPI or bit-bang) design.
Independent Baud rate generators.
RS232/RS422/RS485 UART Transfer Data Rate
up to 12Mbaud. (RS232 Data Rate limited by
external level shifter).
FTDI’s royalty-free Virtual Com Port (VCP) and
Direct (D2XX) drivers eliminate the requirement
for USB driver development in most cases.
Optional traffic TX/RX indicators can be added with
Adjustable receive buffer timeout.
Support for USB suspend and resume conditions via
PWREN#, SUSPEND# and RI# pins.
FTDI FT232R/FT-X style, asynchronous serial UART
interface option with full hardware handshaking and
modem interface signals.
Fully assisted hardware or X-On / X-Off software
UART Interface supports 7/8 bit data, 1/2 stop bits,
and Odd/Even/Mark/Space/No Parity.
Auto-transmit enable control for RS485 serial
applications using TXDEN pin through external
Operational configuration mode and USB Description
strings configurable in external EEPROM over the
Low operating and USB suspend current.
Configurable I/O drive strength (4, 8, 12 or 16mA)
and slew rate.
USB Bulk data transfer mode (512 byte packets in
High Speed mode).
Dedicated Windows DLLs available for USB to SPI,
and USB to I2C applications.
+3.3V single supply operating voltage range.
+3.3V I/O interfacing.
Highly integrated design includes +1.2V LDO
regulator for VCORE, integrated POR function and on
chip clock multiplier PLL (12MHz – 480MHz).
Extended -40°C to 85°C industrial operating
Available in Pb-free QFN-76/QFN-68/LQDP-80
package (RoHS compliant)
Copyright © Future Technology Devices International Limited