Datasheet4U Logo Datasheet4U.com

FT312D - USB Android Host IC

Description

of the function please refer to Section 4.

Features

  • Single chip USB to UART interface.
  • Entire USB protocol handled on the chip. No.
  • USB specific firmware programming required.
  • Supports USB bulk transfer mode.
  • Basic UART interface with RXD, TXD, RTS#, CTS# pins.
  • TX_ACTIVE signal for controlling transceivers.
  • on RS485 interfaces.
  • UART RX buffer size is 5512 bytes.
  • UART TX buffer size is 256 bytes.
  • USB_ERROR indicator pin.
  • Suitable for use on any Andr.

📥 Download Datasheet

Datasheet Details

Part number FT312D
Manufacturer FTDI
File Size 936.74 KB
Description USB Android Host IC
Datasheet download datasheet FT312D Datasheet

📁 Similar Datasheet

  • ft3128 - High Power Stereo Class-D Audio Power Amplifier (Fangtek)
  • FT3103 - Three Phase Sensorless BLDC Motor Controller (Fortior)
  • FT3106 - Three Phase Sensorless BLDC Motor Controller (Fortior)
  • FT3107T - Three Phase Sensorless BLDC Motor Controller (Fortior)
  • FT310N - Sensorless BLDC Motor Controller (Fortior)
  • FT310S - Sensorless BLDC motor controller (Fortior)
  • ft3157 - Low-Ohmic Single-Pole Double-Throw Analog Switch (Fangtek)
  • FT3168 - Self-Capacitance Touch Controller (FocalTech)
  • FT3000AV - Phase Control SCR (Powerex Power Semiconductors)
  • FT3003 - Three Phase Sensorless BLDC Motor Controller (Fortior)
Other Datasheets by FTDI

Full PDF Text Transcription

Click to expand full text
DS_FT312D USB ANDROID HOST IC Datasheet Version 1.2 Document No.: FT_000816 Clearance No.: FTDI# 331 Future Technology Devices International Ltd. DS_FT312D (USB Android Host IC) The FT312D is a USB 2.0 Full Speed host IC specifically targeted at providing access to peripheral hardware from an Android platform with a USB device port. The device will bridge the USB port to a UART interface via the Android Open Accessory protocol and has the following advanced features:  Single chip USB to UART interface.   Entire USB protocol handled on the chip. No  USB specific firmware programming required.  Supports USB bulk transfer mode   Basic UART interface with RXD, TXD, RTS#, CTS# pins.   TX_ACTIVE signal for controlling transceivers  on RS485 interfaces.
Published: |