FT902 Datasheet | FTDI

features : - - - - High performance, low power 32-bit FT32 core processor, running at a frequency of 100MHz. - - 256k B on-chip Flash memory. - 256k B on-chip shadow program memory. - - True Zero Wait States (0WS) up to 3.1 DMIPS per MHz performance - 64k B on-chip data memory. - - EFUSE for security configuration. - - Integrated Phase-Locked Loop (PLL) supports external 12MHz crystal and direct external clock source input. - - 32.768 k Hz real time clock support. - One USB2.0 EHCI patible host controller supports high-speed (480 Mbit/s), full-speed (12 Mbit/s), and low-speed (1.5 Mbit/s). - - One USB2.0 peripheral controller supports highspeed (480 Mbit/s) and full-speed (12 Mbit/s). - - USB2.0 host and peripheral controllers support the Isochronous, Interrupt, Control, and Bulk - transfers. - 10/100 Mbps Ethernet that is pliant with the - IEEE 802.3/802.3u standards. (FT900 and - FT901 only) - Support One-Wire debugger download firmware to Flash memory or shadow program memory, and support software debugger. - - Two CAN controllers support CAN protocol 2.0 parts A & B, data rate is up to 1 Mbit/s. (FT900 - and FT902 only) - - One SPI master supports single / dual / quad modes of data transfer. Clock rate is up to 25 MHz - Two SPI slaves support single data transfer with 25MHz clock. Two I2C bus interfaces can be configured as master or slave, which support standard / fast / fast plus / high speed mode data transfers. Max data transfer rate up to 3.4 Mbit/s. Clock stretching is supported. I2S bus interface can be configured as master or slave. Two clock input options (24.576 MHz and 22.5792 MHz) to support I2S master mode for different audio sample rates. UART interface can be configured as one full programmable UART0 or two simple UART0 and UART1 with CTS / RTS control function. Four user timers with pre-scaling and a watchdog function. 8-bit parallel data interface supports camera data capturing. Support 7 independent PWM channels....