Datasheet4U Logo Datasheet4U.com

74ACT715 - Programmable Video Sync Generator

Description

The ACT715 and ACT715-R are 20-pin TTL-input compatible devices capable of generating Horizontal, Vertical and Composite Sync and Blank signals for televisions and monitors.

All pulse widths are completely definable by the user.

Features

  • s Maximum Input Clock Frequency > 130 MHz s Interlaced and non-interlaced formats available s Separate or composite horizontal and vertical Sync and Blank signals available s Complete control of pulse width via register programming s All inputs are TTL compatible s 8 mA drive on all outputs s Default RS170/NTSC values mask programmed into registers s ACT715-R is mask programmed to default to a Clock Enable state for easier start-up into 14.31818 MHz RS170 timing Ordering Code: Order Number 74AC.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
74ACT74 Dual D-Type Flip-Flop STMicroelectronics
74ACT74P Dual D-Type Flip-Flop Toshiba
74ACT00 Quad 2-Input NAND Gate ON Semiconductor
74ACT00 QUAD 2-INPUT NAND GATE STMicroelectronics
74ACT00 Quadruple 2-Input Positive-NAND Gates Texas Instruments

Other Datasheets by Fairchild (onsemi)

Part Number Description
74ACT715-R Programmable Video Sync Generator
74ACT74 Dual D-Type Positive Edge-Triggered Flip-Flop
74ACT00 Quad 2-Input NAND Gate
74ACT02 Quad 2-Input NOR Gate
74ACT04 Hex Inverter

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.DataSheet4U.com 74ACT715•74ACT715-R Programmable Video Sync Generator November 1988 Revised December 1998 74ACT715•74ACT715-R Programmable Video Sync Generator General Description The ACT715 and ACT715-R are 20-pin TTL-input compatible devices capable of generating Horizontal, Vertical and Composite Sync and Blank signals for televisions and monitors. All pulse widths are completely definable by the user. The devices are capable of generating signals for both interlaced and noninterlaced modes of operation. Equalization and serration pulses can be introduced into the Composite Sync signal when needed. Four additional signals can also be made available when Composite Sync or Blank are used.
Published: |