N-Channel Enhancement Mode Field
Electrical Characteristics (TJ=25°C unless otherwise noted)
Min Typ Max Units
BVDSS Drain-Source Breakdown Voltage
IDSS Zero Gate Voltage Drain Current
IGSS Gate-Body leakage current
Gate Threshold Voltage
On state drain current
RDS(ON) Static Drain-Source On-Resistance
20 25 mΩ
gFS Forward Transconductance
VSD Diode Forward Voltage
IS Maximum Body-Diode Continuous Current G
Ciss Input Capacitance
Coss Output Capacitance
Crss Reverse Transfer Capacitance
Rg Gate resistance
VGS=0V, VDS=10V, f=1MHz
VGS=0V, VDS=0V, f=1MHz
Qg(10V) Total Gate Charge
Qg(4.5V) Total Gate Charge
Qgs Gate Source Charge
Qgd Gate Drain Charge
tr Turn-On Rise Time
tf Turn-Off Fall Time
VGS=10V, VDS=10V, ID=20A
VGS=10V, VDS=10V, RL=0.5Ω,
trr Body Diode Reverse Recovery Time IF=20A, dI/dt=100A/μs
Qrr Body Diode Reverse Recovery Charge IF=20A, dI/dt=100A/μs
A: The value of R θJA is measured
T A =25°C. The Power dissipation
with the device mounted on 1in 2 FR-4 board with
PDSM is based on R θJA and the maximum allowed
2oz. Copper, in a still air environment with
junction temperature0of 150°C. The value in
application depends on the user's specific board design, and the maximum temperature of 175°C may be used if the PCB allows it.
B. The power dissipation PD is based on TJ(MAX)=175°C, using junction-to-case thermal resistance, and is more useful in setting the upper
dissipation limit for cases where additional heatsinking is used.
C: Repetitive rating, pulse width limited by junction temperature T J(MAX)=175°C.
D. The R θJA is the sum of the thermal impedence from junction to case R θJC and case to ambient.
E. The static characteristics in Figures 1 to 6 are obtained using <300 μs pulses, duty cycle 0.5% max.
F. These curves are based on the junction-to-case thermal impedence which is measured with the device mounted to a large heatsink, assuming a
maximum junction temperature of T J(MAX)=175°C.
G. The maximum current rating is limited by bond-wires.
H. These tests are performed with the device mounted on 1 in 2 FR-4 board with 2oz. Copper, in a still air environment with TA=25°C. The SOA
curve provides a single pulse rating.
*This device is guaranteed green after data code 8X11 (Sep 1 ST 2008).
Rev4: Nov 2008
Free Datasheet http://www.datasheet4u.com/