Datasheet4U Logo Datasheet4U.com

33394 - Switch Mode Power Supply

General Description

(44

PIN NO.

Key Features

  • include Active Reset circuitry watching VDDH, VDD3_3, VDDL and VKAM, user selectable Hardware Reset Timer (HRT), Power Sequencing circuitry guarantees the core supply voltages never exceed their limits or polarities during system power up and power down. A high speed CAN transceiver physical layer interfaces between the microcontroller CMOS outputs and differential bus lines. The CAN driver is short circuit protected and tolerant of loss of battery or ground conditions. 33394 is designed specifi.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
33390 Class B Serial Transceiver Motorola Inc
333-2SDRC 5.0mm Round Type LED Lamps Everlight Electronics
333-2SURC 5.0mm Round Type LED Lamps Everlight Electronics
3338S Single Color 3 Round Shape LED STANLEY ELECTRIC
333HD 5.0 MM ROUND TYPE LED LAMPS ETC

Other Datasheets by Freescale Semiconductor (now NXP Semiconductors)

Part Number Description
33395 Three-Phase Gate Driver IC
33395T Three-Phase Gate Driver IC
33399 Local Interconnect Network (LIN) Physical Interface
33385 Quad Low-side Driver
33389 System Basis Chip

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.DataSheet4U.com Freescale Semiconductor,Order Inc. this document from Analog Marketing Rev. 2.5, 11/2002 Switch Mode Power Supply with Multiple Linear Regulators and High Speed CAN Transceiver The 33394 is a multi–output power supply integrated circuit with high speed CAN transceiver. The IC incorporates a switching pre–regulator operating over a wide input voltage range from +4.0V to +26.5V (with transients up to 45V). The switching regulator has an internal 3.0A current limit and runs in both buck mode or boost mode to always supply a pre–regulated output followed by Low Drop Out (LDO) regulators: VDDH / 5.0V @ 400mA; VDD3_3 / 3.3V @ 120mA; VDDL / 2.6V (User scalable between 3.3V – 1.25V) @ 400mA typically, using an external NPN pass transistor.