MC10XS3412 Datasheet | Freescale Semiconductor

Features - Four protected 10mΩ and 12mΩ high side switches (at 25°C) - Operating voltage range of 6.0V to 20V with sleep current < 5.0μA, extended mode from 4.0V to 28V - 8MHz 16-bit 3.3V and 5V SPI control and status reporting with daisy chain capability - PWM module using external clock or calibratable internal oscillator with programmable outputs delay management - Smart over-current shutdown, severe short-circuit, overtemperature protections with time limited autoretry, and fail-safe mode in case of MCU damage - Output OFF or ON open-load detection pliant to bulbs or LEDs and short to battery detection. Analog current feedback with selectable ratio and board temperature feedback. 10XS3412 HIGH SIDE SWITCH PNA SUFFIX (PB-FREE) 98ARL10596D 24-PIN PQFN ORDERING INFORMATION Device MC10XS3412CPNA Temperature Range (TA) - 40°C to 125°C Package 24 PQFN VPWR VPWR 10XS3412 VDD I/O SCLK CS SI I/O MCU SO I/O I/O I/O I/O A/D GND WAKE FS SCLK CS SO RST SI IN0 IN1 IN2 IN3 CSNS FSI GND VPWR HS0 LOAD HS1 LOAD HS2 LOAD HS3 LOAD Figure 1. 10XS3412 Simplified Application Diagram - This document contains certain information on a new product. Specifications and information herein are subject to change without notice. © Freescale Semiconductor, Inc., 2008. All rights reserved. INTERNAL BLOCK DIAGRAM INTERNAL BLOCK DIAGRAM .. VPWR IUP CS SCLK IDWN SO SI RST WAKE FS IN0 IN1 IN2 IN3 VDD Failure Detection Internal Regulator VREG Over/Under-voltage Protections Charge Pump VPWR Voltage Clamp Selectable Slew Rate Gate Driver Selectable Over-current Detection Severe Short-circuit Detection Short to VPWR Detection Over-temperature Detection Open-load Detections HS0 Logic HS0 RDWN IDWN RDWN HS1 Calibratable Oscillator VREG PWM...