FT232H Datasheet | Future Technology Devices

features : - Single channel USB to serial / parallel ports with a variety of configurations. - Entire USB protocol handled on the chip. No USB specific firmware programming required. - USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) patible. - Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design. - UART transfer data rate up to 12Mbaud. (RS232 Data Rate limited by external level shifter). - USB to asynchronous 245 FIFO mode for transfer data rate up to 8 Mbyte/Sec. - USB to synchronous 245 parallel FIFO mode for transfers up to 40 Mbytes/Sec - Supports a proprietary half duplex FT1248 interface with a configurable width, bidirectional data bus (1, 2, 4 or 8 bits wide). - CPU-style FIFO interface mode simplifies CPU interface design. - Fast serial interface option. - FTDI’s royalty-free Virtual Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases. - Adjustable receive buffer timeout. - - - - - - - - - - - - - - - - - Option for transmit and receive LED drive signals. Bit-bang Mode interface option with RD# and WR# strobes Highly integrated design includes 5V to 3.3/+1.8V LDO regulator for VCORE, integrated POR function Asynchronous serial UART interface option with full hardware handshaking and modem interface signals. Fully assisted hardware or X-On / X-Off software handshaking. UART Interface supports 7/8 bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity. Auto transmit enable control for RS485 serial applications using the TXDEN pin. Operational mode configuration and USB Description strings configurable in external EEPROM over the USB interface. Configurable I/O drives strength (4, 8, 12 or 16m A) and slew rate. Low operating and USB suspend current. Supports self-powered, bus powered and highpower bus powered USB configurations. UHCI/OHCI/EHCI host controller patible. USB Bulk data transfer mode...