Datasheet4U Logo Datasheet4U.com

IRSF3010 - FULLY PROTECTED POWER MOSFET SWITCH

Description

The IRSF3010 is a three terminal monolithic SMART POWER MOSFET with built in short circuit, over-temperature, ESD and over-voltage protections.

Features

  • n Extremely Rugged for Harsh Operating Environments n Over Temperature Protection n Over Current Protection n Active Drain to Source Clamp n ESD Protection n Compatible with standard POWER MOSFET n Low Operating Input Current n Monolithic Construction n Dual set/reset Threshold Input.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
IRS-12-4.5-Q48 Wide Input Isolated DC-DC Converters muRata
IRS-3.3-15-Q48 Wide Input Isolated DC-DC Converters muRata
IRS-5-10-Q48 Wide Input Isolated DC-DC Converters muRata
IRS-A200ST01-R1 Pyroelectric infrared sensor Murata
IRS-A201ST01-R1 Pyroelectric infrared sensor Murata

Other Datasheets by International Rectifier (now Infineon)

Part Number Description
IRSF3011 FULLY PROTECTED POWER MOSFET SWITCH
IRSF3021 FULLY PROTECTED POWER MOSFET SWITCH
IRSF3031 FULLY PROTECTED POWER MOSFET SWITCH
IRS2001 HIGH AND LOW SIDE DRIVER
IRS2001MPBF HIGH AND LOW SIDE DRIVER

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
Provisional Data Sheet No.PD-6.0027A IRSF3010 FULLY PROTECTED POWER MOSFET SWITCH General Description: The IRSF3010 is a three terminal monolithic SMART POWER MOSFET with built in short circuit, over-temperature, ESD and over-voltage protections. The on chip protection circuit latches off the POWER MOSFET in case the drain current exceeds 14A (typical) or the junction temperature exceeds 165°C (typical) and keeps it off until the input is driven low. The drain to source voltage is actively clamped at 55V (typical), prior to the avalanche of POWER MOSFET, thus improving its performance during turn off with inductive loads. The input current requirements are very low (300uA) which makes the IRSF3010 compatible with most existing designs based on standard POWER MOSFETs.
Published: |