Datasheet4U Logo Datasheet4U.com

EL2142 - Differential Line Receiver

General Description

MIN TYP MAX VSUPPLY IS VOS IIN ZIN CIN VDIFF AVOL VIN VOUT IOUT(min) VN VREF PSRR Supply Operating Range (VCC-VEE) Power Supply Current (no load) Input Referred Offset Voltage Input Bias Current (VIN, VINB, VREF) Differential Input Resistance Differential Input Capacitance Differential Input Rang

Key Features

  • Differential input range ±2.3V.
  • 150MHz 3dB bandwidth.
  • 400V/µs slewrate.
  • ±5V supplies or single supply.
  • 50mA minimum output current.
  • Output swing (100Ω load) to within 1.5V of supplies.
  • Low power-11mA typical supply current.
  • Pb-free available (RoHS compliant).

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
EL2142C Differential Line Receiver Elantec
EL2140C 150 MHz Differential Twisted Pair Driver Elantec
EL2141C 150 MHz Differential Twisted Pair Driver Elantec
EL211 8 PIN SOP PHOTOTRANSISTOR PHOTOCOUPLER Everlight
EL212 8 PIN SOP PHOTOTRANSISTOR PHOTOCOUPLER Everlight

Other Datasheets by Intersil (Renesas)

Part Number Description
EL2140 150MHz Differential Twisted Pair Driver
EL2141 150MHz Differential Twisted Pair Driver
EL2120 100MHz Current Feedback Amplifier
EL2126 Ultra-Low Noise/ Low Power/ Wideband Amplifier
EL2130 85MHz Current Feedback Amplifier

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
® Data Sheet February 11, 2005 EL2142 FN7049.1 Differential Line Receiver The EL2142 is a very high bandwidth amplifier designed to extract the difference signal from noisy environments, and is thus primarily targeted for applications such as receiving signals from twisted pair lines, or any application where common mode noise injection is likely to occur. The EL2142 is stable for a gain of one, and requires two external resistors to set the voltage gain. The output common mode level is set by the reference pin (VREF), which has a -3dB bandwidth of over 100MHz. Generally, this pin is grounded, but it can be tied to any voltage reference. The output can deliver a minimum of ±50mA and is short circuit protected to withstand a temporary overload condition.