Datasheet4U Logo Datasheet4U.com

CD4047BMS - CMOS Low-Power Monostable/Astable Multivibrator

Description

CD4047BMS consists of a gatable astable multivibrator with logic techniques incorporated to permit positive or negative edge triggered monostable multivibrator action with retriggering and external counting options.

Inputs include +TRIGGER, -TRIGGER, ASTABLE, ASTABLE, RETRIGGER, and EXTERNAL RESET.

Features

  • High Voltage Type (20V Rating).
  • Low Power Consumption: Special CMOS Oscillator Configuration.
  • Monostable (One-Shot) or Astable (Free-Running) Operation.
  • True and Complemented Buffered Outputs.
  • Only One External R and C Required.
  • Buffered Inputs.
  • 100% Tested for Quiescent Current at 20V.
  • Standardized, Symmetrical Output Characteristics.
  • 5V, 10V and 15V Parametric Ratings.
  • Meets All Requirements of JEDEC Tent.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
CD4047BM Low Power Monostable/Astable Multivibrator National Semiconductor
CD4047BM CMOS LOW-POWER MONOSTABLE/ASTABLE MULTIVIBRATOR Texas Instruments
CD4047B CMOS LOW-POWER MONOSTABLE/ASTABLE MULTIVIBRATOR RCA
CD4047B CMOS LOW-POWER MONOSTABLE/ASTABLE MULTIVIBRATOR Texas Instruments
CD4047BC Low Power Monostable/Astable Multivibrator National Semiconductor

Other Datasheets by Intersil (Renesas)

Part Number Description
CD4040BMS CMOS Ripple-Carry Binary Counter/Dividers
CD4041UBMS CMOS Quad True/Complement Buffer
CD4042BMS CMOS Quad Clocked D-Latch
CD4043BMS CMOS Quad 3 State R/S Latche
CD4044BMS CMOS Quad 3 State R/S Latche

Full PDF Text Transcription

Click to expand full text
CD4047BMS December 1992 CMOS Low-Power Monostable/Astable Multivibrator Description CD4047BMS consists of a gatable astable multivibrator with logic techniques incorporated to permit positive or negative edge triggered monostable multivibrator action with retriggering and external counting options. Inputs include +TRIGGER, -TRIGGER, ASTABLE, ASTABLE, RETRIGGER, and EXTERNAL RESET. Buffered outputs are Q, Q, and OSCILLATOR. In all modes of operation, an external capacitor must be connected between C-Timing and RC-Common terminals, and an external resistor must be connected between the R-Timing and RCCommon terminals. Astable operation is enabled by a high level on the ASTABLE input or a low level on the ASTABLE input, or both.
Published: |