HA1-5320883 Datasheet PDF - Intersil Corporation High Speed Precision Sample and Hold Amplifier Specs

HA1-5320883 - High Speed Precision Sample and Hold Amplifier

Datasheet Summary

Description

The HA-5320/883 was designed for use in precision, high speed data acquisition systems.

The circuit consists of an input transconductance ampliﬁer capable of providing large amounts of charging current, a low leakage analog switch, and an output integrating ampliﬁer.

Features

This Circuit is Processed in Accordance to MIL-STD883 and is Fully Conformant Under the Provisions of Paragraph 1.2.1.
Gain, DC.
. . . . 2 x 106 V/V (Typ).
Acquisition Time.
1.0µs (0.01%) (Typ).
Droop Rate.
. 0.08µV/µs (+25oC) (Typ) 17µV/µs (Full Temperature) (Typ).
Aperture Time.
2.

Datasheet Details

Part number	HA1-5320883
Manufacturer	Intersil Corporation
File Size	90.65 KB
Description	High Speed Precision Sample and Hold Amplifier
Datasheet	HA1-5320883 Datasheet
Additional preview pages of the HA1-5320883 datasheet.

📁 Similar Datasheet

HA10 - Current Transducer 5/10a (LEM)

HA1099 - 18-pin Flash microcontroller Introduction (Microchip)

HA11 - 1.0 AMP.HIGH EFFICIENCY RECTIFIERS (Jinan Gude Electronic Device)

HA11122W - Amplifier System (Hitachi)

HA11211 - FM / AM Stereo Receiver System (Hitachi)

HA11215A - Color TV Picture IF System (Renesas Technology)

HA11215A - COLOR TV PICTURE IF SYSTEM (Hitachi Semiconductor)

HA11219 - Noise Suppressor System (Hitachi)

HA11221 - B/W TV Picture IF Amplifier (Hitachi Semiconductor)

HA11223 - PLL FM Stereo Demodulator (Hitachi)

Full PDF Text Transcription

Click to expand full text

HA5320/883 July 1994 High Speed Precision Sample and Hold Ampliﬁer Description The HA-5320/883 was designed for use in precision, high speed data acquisition systems. The circuit consists of an input transconductance ampliﬁer capable of providing large amounts of charging current, a low leakage analog switch, and an output integrating ampliﬁer. The analog switch sees virtual ground as its load; therefore, charge injection on the hold capacitor is constant over the entire input/ output voltage range. The pedestal voltage resulting from this charge injection can be adjusted to zero by use of the offset adjust inputs. The device includes a hold capacitor. However, if improved droop rate is required at the expense of acquisition time, additional hold capacitance may be added externally.

Published: Mar 22, 2005 |