900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf




Intersil Electronic Components Datasheet

IPM6210A Datasheet

Precision Dual PWM Controller And Linear Regulator

No Preview Available !

TM
Data Sheet
IPM6210A
August 2001
File Number 9033.1
Precision Dual PWM Controller And
Linear Regulator for Notebook CPUs
The IPM6210A is a highly integrated power controller which
provides a complete power management solution for mobile
CPUs. The IC integrates two PWM controllers and a linear
regulator as well as monitoring and protection circuitry into a
single 28-lead plastic SSOP package. The two PWM
controllers regulate the microprocessor core and I/O
voltages with synchronous-rectified buck converters, while
the linear regulator powers the CPU clock.
The IPM6210A includes 5-bit digital-to-analog converter
(DAC) that adjusts the core PWM output voltage from
0.925VDC to 2.0VDC and conforms to the Intel Mobile VID
specification. The DAC setting may be changed during
operation to accommodate Dual-Mode processors. Special
measures are taken to provide such a transition with
controlled rate in a specified 100µs. A precision reference,
remote sensing, and a proprietary architecture with
integrated processor mode-compensated “droop” provide
excellent static and dynamic core voltage regulation. The
second PWM controller has a fixed 1.5V output voltage and
powers the I/O circuitry. Both PWM controllers have
integrated feedback loop compensation that dramatically
reduces number of the external components. At nominal
loads PWM controllers operate at a fixed frequency of
300kHz. At light loads when the filter inductor current
becomes discontinuous, controllers operate in a hysteretic
mode. Out-of-phase operation of two PWM controllers to
reduce input current ripple is provide in both modes of
www.oDpaetarSahtioeent.4TUh.ceomlinear regulator uses an internal pass device
to provide 2.5V for the CPU clock generator.
The IPM6210A monitors all the output voltages. A single
Power-Good signal is issued when soft start is completed
and all outputs are within ±10% of their respective set points.
A built-in overvoltage protection for the core and I/O outputs
forces the lower MOSFETs on to prevent output voltages
from going above 115% of their settings. Undervoltage
protection latches the chip off when any of three outputs
drops below 75% of the set value. The PWM controller's
overcurrent circuitry monitors the output current by sensing
the voltage drop across the lower MOSFETs. If precision
overcurrent protection is required, an external current-sense
resistor may optionally be used.
Ordering Information
PART NUMBER TEMP. (oC)
PACKAGE
IPM6210ACA
-10 to 85 28 Ld SSOP
IPM6210ACA-T
-10 to 85 28 Ld SSOP,
Tape and Reel
PKG. NO.
M28.15
M28.15
Features
• Provides 3 Regulated Voltages
- 0.9V to 2.0V Microprocessor Core (SpeedStepTM
Enabled)
- 1.5V Microprocessor I/O
- 2.5V Microprocessor Clock Generator
• High Efficiency Over Wide Load Range
• Not Dissipative Current-Sense Scheme
- Uses MOSFET’s rDS(ON)
- Optional Current-Sense Resistor for Precision
Overcurrent
• Adaptive Dead-Time Drivers for N-Channel MOSFETs
• Operates from +5V, +3.3V and Battery (5.6-24V) Inputs
• Precision Core Voltage Control:
- Remote “Kelvin” Sensing
- Summing Current-Mode Control
- On-Chip Mode-Compensated “Droop” for Optimum
Transient Response and Lower Processor Power
Dissipation
• TTL-Compatible 5-Bit Digital Output Voltage Selection
- Wide Range - 0.925VDC to 1.3VDC in 25mV Steps, and
from 1.3VDC to 2.0VDC in 50mV Steps
- Programmable “On-the-Fly” VID Code Change with
Customer Programmable Slew Rate and 100µs Settling
Time
• Power-Good Output Voltage Monitor
• No Negative Voltage on Outputs at Turn-Off
• Overvoltage, Undervoltage and Overcurrent Fault
Monitors
• 300kHz Fixed Switching Frequency
• Thermal Shutdown
Applications
• Mobile PCs
Web Tablets
Internet Appliances
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil and Design is a trademark of Intersil Americas Inc.
SpeedStep™ is a trademark of Intel Corporation. | Copyright © Intersil Americas Inc. 2001, All Rights Reserved


Intersil Electronic Components Datasheet

IPM6210A Datasheet

Precision Dual PWM Controller And Linear Regulator

No Preview Available !

Pinout
IPM6210A
IPM6210A (SSOP)
TOP VIEW
LGATE2 1
PGND2 2
BOOT2 3
UGATE2 4
PHASE2 5
ISEN2 6
VID4 7
VID3 8
VID2 9
VID1 10
VID0 11
VSEN2 12
V3IN 13
VOUT3 14
28 VCC
27 LGATE1
26 PGND1
25 BOOT1
24 UGATE1
23 PHASE1
22 ISEN1
21 PGOOD
20 EN
19 VIN
18 SOFT
17 VSEN1
16 VRET1
15 GND
Simplified Power System Diagram
+VIN
VOUT2
I/O
PWM2
CONTROLLER
PWM1
CONTROLLER
www.DataShe+eVtI4NU.com
3.3V
VOUT3
CPU CLK
LINEAR
REGULATOR
VID CODE
IPM6210A
VOUT1
CORE
2


Part Number IPM6210A
Description Precision Dual PWM Controller And Linear Regulator
Maker Intersil Corporation
Total Page 15 Pages
PDF Download

IPM6210A Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 IPM6210A Precision Dual PWM Controller And Linear Regulator
Intersil Corporation





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy