UMV4301 Datasheet | LS

Réf. 3035 - 4.33 / a - 11.98 .. X-1 0 1 0 Max. sp Min. spe Negativ speed s 1 1 0 0 1 Synchro output speed reference Menu 13 Synchro out speed refere selection Menu 13 Skip frequency 1 Skip width 1 01.29 01.30 01.3 g t Run FWD 27 Run REV 28 00.03 Accele 00.04 Decele 00.02 Maximum limit 00.01 Minimum limit x (-1) 00.11 give e b t s ual mu user n a m This end to the n Reference before ramp Speed skip 00.20 00.22 Skip width 00.21 00.23 R a "S" ramp selection 00.18 Select Ramp curve in "S " 00.19 stopping Standard with mode automatic extension 0 (Stnd. Hd) Fixed ramp 1 00.15 (FAST) Select deceleration Controlled ramp mode (St d Ct) 2 UMV 4301 Open and closed loop speed controllers for asynchronous and synchronous motors Settings and synoptic views UMV 4301 Open and closed loop speed controllers for asynchronous and synchronous motors NOTE LEROY-SOMER reserves the right to modify the characteristics of its products at any time in order to incorporate the latest technological developments. The information contained in this document may therefore be changed without notice. LEROY-SOMER gives no contractual guarantee whatsoever concerning the information published in this document and cannot be held responsible for any errors it may contain, nor for any damage arising from its use. .. CAUTION For the user's own safety, this speed controller must be connected to an approved earth ( B terminal). If an accidental start of the installation represents a risk for personnel or the machinery to be driven, it is imperative that the equipment is supplied via an isolating device and a circuit-breaking device (power contactor) which can be controlled by an external safety system (emergency stop, fault detector). The speed controller is fitted with safety devices which can stop the speed controller and therefore stop the motor. The motor itself can bee jammed for mechanical reasons. Finally, voltage fluctuations, and in particular power...