900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf




Linear Technology Electronic Components Datasheet

LTC3411EDD Datasheet

Step-Down DC/DC Converter

No Preview Available !

FEATURES
n Small 10-Lead MSOP or DFN Package
n Uses Tiny Capacitors and Inductor
n High Frequency Operation: Up to 4MHz
n High Switch Current: 1.6A
n Low RDS(ON) Internal Switches: 0.110Ω
n High Efficiency: Up to 95%
n Stable with Ceramic Capacitors
n Current Mode Operation for Excellent Line
and Load Transient Response
n Short-Circuit Protected
n Low Dropout Operation: 100% Duty Cycle
n Low Shutdown Current: IQ ≤ 1μA
n Low Quiescent Current: 60μA
n Output Voltages from 0.8V to 5V
n Selectable Burst Mode® Operation
n Synchronizable to External Clock
APPLICATIONS
n Notebook Computers
n Digital Cameras
n Cellular Phones
n Handheld Instruments
n Board Mounted Power Supplies
LTC3411
1.25A, 4MHz, Synchronous
Step-Down DC/DC Converter
DESCRIPTION
The LTC®3411 is a constant frequency, synchronous,
step- down DC/DC converter. Intended for medium power
applications, it operates from a 2.63V to 5.5V input voltage
range and has a user configurable operating frequency
up to 4MHz, allowing the use of tiny, low cost capacitors
and inductors 2mm or less in height. The output voltage
is adjustable from 0.8V to 5V. Internal sychronous 0.11Ω
power switches with 1.6A peak current ratings provide
high efficiency. The LTC3411’s current mode architecture
and external compensation allow the transient response
to be optimized over a wide range of loads and output
capacitors.
The LTC3411 can be configured for automatic power sav-
ing Burst Mode operation to reduce gate charge losses
when the load current drops below the level required for
continuous operation. For reduced noise and RF interfer-
ence, the SYNC/MODE pin can be configured to skip pulses
or provide forced continuous operation.
To further maximize battery life, the P-channel MOSFET
is turned on continuously in dropout (100% duty cycle)
with a low quiescent current of 60μA. In shutdown, the
device draws <1μA.
L, LT, LTC and LTM are registered trademarks of Linear Technology Corporation.
Burst Mode is a registered trademark of Linear Technology Corporation.
TYPICAL APPLICATION
13k
1000pF
VIN
2.63V TO 5.5V
VIN SYNC/MODE
PVIN
PGOOD
SVIN
SW
LTC3411
ITH
SHDN/RT
SGND
VFB
PGND
324k
C1
22μF
L1
2.2μH
887k
412k
VOUT
2.5V/1.25A
C2
22μF
NOTE: IN DROPOUT, THE OUTPUT TRACKS
THE INPUT VOLTAGE
C1, C2: TAIYO YUDEN JMK325BJ226MM
L1: TOKO A914BYW-2R2M (D52LC SERIES)
3411 F01
Figure 1. Step-Down 2.5V/1.25A Regulator
Efficiency vs Load Current
100
95
90
85
80
VIN = 3.3V
75 VOUT = 2.5V
fO = 1MHz
Burst Mode OPERATION
70
1
10
100
LOAD CURRENT (mA)
1000
3411 TA01
3411fb
1


Linear Technology Electronic Components Datasheet

LTC3411EDD Datasheet

Step-Down DC/DC Converter

No Preview Available !

LTC3411
ABSOLUTE MAXIMUM RATINGS (Note 1)
PVIN, SVIN Voltages ..................................... –0.3V to 6V
VFB, ITH, SHDN/RT Voltages ..........–0.3V to (VIN + 0.3V)
SYNC/MODE Voltage .....................–0.3V to (VIN + 0.3V)
SW Voltage ..................................–0.3V to (VIN + 0.3V)
PGOOD Voltage ........................................... –0.3V to 6V
Operating Temperature Range (Note 2)
LTC3411E............................................. –40°C to 85°C
LTC3411I............................................ –40°C to 125°C
Junction Temperature (Notes 5, 8) ....................... 125°C
Storage Temperature Range
DD Package ....................................... –65°C to 125°C
MS Package ...................................... –65°C to 150°C
Lead Temperature (Soldering, 10 sec) .................. 300°C
PIN CONFIGURATION
TOP VIEW
SHDN/RT 1
SYNC/MODE 2
SGND 3
SW 4
PGND 5
10 ITH
9 VFB
8 PGOOD
7 SVIN
6 PVIN
DD PACKAGE
10-LEAD (3mm s 3mm) PLASTIC DFN
TJMAX = 125°C, θJA = 43°C/W, θJC = 8°C/W
(EXPOSED PAD MUST BE SOLDERED TO SGND)
TOP VIEW
SHDN/RT 1
SYNC/MODE 2
SGND 3
SW 4
PGND 5
10 ITH
9 VFB
8 PGOOD
7 SVIN
6 PVIN
MS PACKAGE
10-LEAD PLASTIC MSOP
TJMAX = 125°C, θJA = 120°C/W, θJC = 45°C/W
ORDER INFORMATION
LEAD FREE FINISH
TAPE AND REEL
PART MARKING*
PACKAGE DESCRIPTION
TEMPERATURE RANGE
LTC3411EDD#PBF
LTC3411EDD#TRPBF
LADT
10-Lead (3mm × 3mm) Plastic DFN
–40°C to 85°C
LTC3411IDD#PBF
LTC3411IDD#TRPBF
LADT
10-Lead (3mm × 3mm) Plastic DFN
–40°C to 125°C
LTC3411EMS#PBF
LTC3411EMS#TRPBF LTQT
10-Lead Plastic MSOP
–40°C to 85°C
LTC3411IMS#PBF
LTC3411IMS#TRPBF
LTQT
10-Lead Plastic MSOP
–40°C to 125°C
LEAD BASED FINISH
TAPE AND REEL
PART MARKING*
PACKAGE DESCRIPTION
TEMPERATURE RANGE
LTC3411EDD
LTC3411EDD#TR
LADT
10-Lead (3mm × 3mm) Plastic DFN
–40°C to 85°C
LTC3411IDD
LTC3411IDD#TR
LADT
10-Lead (3mm × 3mm) Plastic DFN
–40°C to 125°C
LTC3411EMS
LTC3411EMS#TR
LTQT
10-Lead Plastic MSOP
–40°C to 85°C
LTC3411IMS
LTC3411IMS#TR
LTQT
10-Lead Plastic MSOP
–40°C to 125°C
Consult LTC Marketing for parts specified with wider operating temperature ranges. *The temperature grade is identified by a label on the shipping container.
For more information on lead free part marking, go to: http://www.linear.com/leadfree/
For more information on tape and reel specifications, go to: http://www.linear.com/tapeandreel/
3411fb
2


Part Number LTC3411EDD
Description Step-Down DC/DC Converter
Maker Linear
PDF Download

LTC3411EDD Datasheet PDF






Similar Datasheet

1 LTC3411EDD Step-Down DC/DC Converter
Linear





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z



Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy