LTC3603 Datasheet | Linear Technology

Features n Wide Input Voltage Range: 4.5V to 15V n 2.5A Output Current n Low RDS(ON) Internal Switches: 45mΩ and 85mΩ n Programmable Frequency: 300k Hz to 3MHz n Low Quiescent Current: 75µA n 0.6V ±1% Reference Allows Precise, Low Output Voltage n 99% Maximum Duty Cycle n Adjustable Burst Mode® Clamp n Synchronizable to External Clock n Power Good Output Voltage Monitor n Overtemperature Protection n Overvoltage Protection n Available in 16-Lead Thermally Enhanced e MSOP and 4mm × 4mm QFN Packages Applications n Point-of-Load Supplies n Portable Instruments n munications Infrastructure LTC3603 2.5A, 15V Monolithic Synchronous Step-Down Regulator Description The LTC®3603 is a high efficiency, monolithic synchronous step-down DC/DC converter utilizing a constant-frequency, current mode architecture. It operates from an input voltage range of 4.5V to 15V and provides an adjustable regulated output voltage from 0.6V to 14.5V while delivering up to 2.5A of output current. The internal synchronous power switch with 45mΩ on-resistance increases efficiency and eliminates the need for an external Schottky diode. The switching frequency can either be set by an external resistor or synchronized to an external clock. OPTI-LOOP® pensation allows the transient response to be optimized over a wide range of loads and output capacitors. The LTC3603 can be configured for either Burst Mode operation or forced continuous operation. Forced continuous operation reduces noise and RF interference, while Burst Mode operation provides the highest efficiency at light loads. In Burst Mode operation, external control of the burst clamp level allows the output voltage ripple to be adjusted according to the requirements of the application. L, LT, LTC, LTM, Burst Mode, OPTI-LOOP, Linear Technology and the Linear logo are registered trademarks and Thin SOT is a trademark of Linear Technology Corporation. All other trademarks are the property of their respective owners. Protected by...