LT1006 Datasheet | Linear Technology

FEATURES - Single Supply Operation Input Voltage Range Extends to Ground Output Swings to Ground while Sinking Current - Guaranteed Offset Voltage: 50µV Max - Guaranteed Low Drift: 1.3µV/°C Max - Guaranteed Offset Current: 0.5n A Max - Guaranteed High Gain 5m A Load Current: 1.5 Million Min 17m A Load Current: 0.8 Million Min - Guaranteed Low Supply Current: 520µA Max - Supply Current can be Reduced by a Factor of 4 - Low Voltage Noise, 0.1Hz to 10Hz: 0.55µVP-P Low Current Noise- Better than OP-07: 0.07p A/√Hz at 10Hz - High Input Impedance: 250MΩ Min - Minimum Supply Voltage: 2.7V Min U APPLICATIO S - Low Power Sample-and-Hold Circuits - Battery-Powered Precision Instrumentation Strain Gauge Signal Conditioners Thermocouple Amplifiers - 4m A to 20m A Current Loop Transmitters - Active Filters Precision, Single Supply Op Amp DESCRIPTIO The LT®1006 is the first precision single supply operational amplifier. Its design has been optimized for single supply operation with a full set of specifications at 5V. Specifications at ±15V are also provided. The LT1006 has a low offset voltage of 20µV, drift of 0.2µV/°C, offset current of 120p A, gain of 2.5 million, mon mode rejection of 114d B and power supply rejection of 126d B. Although supply current is only 340µA, a novel output stage can source or sink in excess of 20m A while retaining high voltage gain. mon mode input range includes ground to acmodate low ground-referenced inputs from strain gauges or thermocouples, and output can swing to within a few millivolts of ground. If a higher slew rate (in excess of 1V/µs) or micropower operation (supply current down to 90µA) is required, the operating currents can be modified by connecting an external optional resistor to Pin 8. For similar single supply precision dual and quad op amps, please see the LT1013/LT1014 data sheet. For micropower dual and quad op amps, please see the LT1078/LT1079 data sheet. , LTC and LT are registered trademarks of Linear Technology...