900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






Littelfuse

MCR106-6 Datasheet Preview

MCR106-6 Datasheet

Sensitive Gate Silicon Controlled Rectifiers

No Preview Available !

MCR106-6, MCR106-8
Thyristors
Surface Mount – 400V - 600V > MCR106-6, MCR106-8
Pb
Description
PNPN devices designed for high volume consumer
applications such as temperature, light and speed control;
process and remote control, and warning systems where
reliability of operation is important.
Features
• Glass-Passivated Surface
for Reliability and
Uniformity
• Power Rated at
Economical Prices
• Practical Level
Triggering and Holding
Characteristics
• Flat, Rugged, Thermopad
Construction for Low
Thermal Resistance, High
Heat Dissipation and
Durability
• Lead-free Packages are
Available
Pin Out
321
T0-225AA
Case 77
Style 2
Functional Diagram
A
G
K
Additional Information
Datasheet
Resources
Samples
© 2020 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: 08/18/20




Littelfuse

MCR106-6 Datasheet Preview

MCR106-6 Datasheet

Sensitive Gate Silicon Controlled Rectifiers

No Preview Available !

Thyristors
Surface Mount – 400V - 600V > MCR106-6, MCR106-8
Maximum Ratings (TJ = 25°C unless otherwise noted)
Rating
Symbol
Value
Unit
Peak Repetitive Off−State Voltage (Note 1)
(− 40 to 110°C, Sine Wave, 50 to 60 Hz, RGK=1Kohm)
On-State RMS Current
(180º Conduction Angles; TC = 93ºC)
Peak Non-Repetitive Surge Current
(1/2 Cycle, Sine Wave 60 Hz, TJ = 110°C
Average On-State Current
(180º Conduction Angles; TC = 93ºC)
Circuit Fusing Consideration (t = 8.3 ms)
MCR106-6
VDRM,
400
MCR106-8
VRRM
600
V
ITM (RMS)
4.0
A
ITSM
25
A
IT(AV)
2.55
A
I2t
2.6
A²s
Forward Peak Gate Power ((TC = 93°C, Pulse Width ≤ 1.0 µs)
Forward Average Gate Power, (TC = 93ºC, t = 8.3 ms)
Forward Peak Gate Current, (TC = 93°C, Pulse Width ≤ 1.0 µs)
Peak Reverse Gate Voltage, (TC = 93°C, Pulse Width ≤ 1.0 µs)
Operating Junction Temperature Range
Storage Temperature Range
Mounting Torque
PGM
PG(AV)
IGM
VRGM
TJ
Tstg
0.5
0.1
0.2
6.0
-40 to +110
-40 to +150
6.0
W
W
A
V
°C
°C
in. lb.
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected.
1. VDRM and VRRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate voltage shall not be applied concurrent with negative potential on the anode. Blocking voltages
shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded.
2. Torque rating applies with use of compression washer (B52200-F006 or equivalent). Mounting torque in excess of 6 in. lb. does not appreciably lower case-to-sink thermal resistance. Anode lead and heatsink contact pad are
common. (See AN209B). For soldering purposes (either terminal connection or device mounting), soldering temperatures shall not exceed +200°C. For optimum results, an activated flux (oxide removing) is recommended.
Thermal Characteristics
Rating
Thermal Resistance,
Junction−to−Case (AC)
Junction−to−Ambient
Maximum Lead Temperature for Soldering Purposes, 1/8” from case for
10 seconds
Symbol
RƟJC
RƟJA
TL
Electrical Characteristics - OFF (TJ = 25°C unless otherwise noted)
Characteristic
Peak Repetitive Forward or Reverse Blocking Current
(VAK = Rated VDRM and VRRM; RGK=1Kohm)
TJ = 25°C
TJ = 110°C
Symbol
IDRM,
IRRM
Min
-
-
Value
3.0
75
260
Typ
-
-
Unit
°C/W
°C
Max
10
200
Unit
µA
Electrical Characteristics - ON (TJ = 25°C unless otherwise noted)
Characteristic
Symbol
Min
Typ
Max
Peak Forward On−State Voltage (Note 3) (ITM = 4 A Peak)
VTM
_
_
2.0
Gate Trigger Current (Continuous DC) (Note 4)
(VAK = 7 Vdc;
RL = 100 Ω)
IGT
_
_
200
(TC = −40ºC)
_
_
500
Gate Trigger Voltage (Continuous DC) (Note 4) (VAK = 12 V; RL = 100 Ω, TJ=110°C)
VGT
_
_
1.0
Gate Trigger Non-Trigger Voltage (Note 4) VAK = 12VDC; RL = 100 Ω)
VGD
0.2
_
_
Holding Current
(VAK=7V,, Initiating Current = 200 mA, RGK = 1kΩ)
IH
_
_
5.0
Unit
V
µA
V
V
mA
© 2020 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: 08/18/20


Part Number MCR106-6
Description Sensitive Gate Silicon Controlled Rectifiers
Maker Littelfuse
PDF Download

MCR106-6 Datasheet PDF






Similar Datasheet

1 MCR106-1 SILICON CONTROLLED RECTIFIERS
Digitron Semiconductors
2 MCR106-2 Silicon Controlled Rectifiers
Motorola
3 MCR106-2 SILICON CONTROLLED RECTIFIERS
Digitron Semiconductors
4 MCR106-3 Silicon Controlled Rectifiers
Motorola
5 MCR106-3 SILICON CONTROLLED RECTIFIERS
Digitron Semiconductors
6 MCR106-4 Silicon Controlled Rectifiers
Motorola
7 MCR106-4 SILICON CONTROLLED RECTIFIERS
Digitron Semiconductors
8 MCR106-5 SILICON CONTROLLED RECTIFIERS
Digitron Semiconductors
9 MCR106-6 Sensitive Gate Silicon Controlled Rectifiers
ON





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy