AM-143 / AMC-143
Low Noise Amplifier, 16 dB Gain,
5 - 500 MHz
1.9 dB Typical Midband Noise Figure
+7 dBm Typical Midband Output Power
+20 dBm Typical Third Order Intercept
M/A-COM’s AM-143 is a coupler feedback amplifier
with low noise figure and high intercept points for the
low bias current. The use of coupler feedback
minimizes noise figure and current in a high intercept
amplifier. This amplifier is packaged in a TO-8
package. The ground plane on the PC board should
be configured to remove heat from under the
package. AM-143 are ideally suited for use where a
low noise, high reliability amplifier is required.
AM-143 PIN 3
3. Mounting kit part number AU00071 required for PCB
Outline Drawing: SMA Connectorized *
Absolute Maximum Ratings 1
Max. Input Power
-55°C to +85°C
-65°C to +125°C
1. Operation of this device above any one of these parameters
may cause permanent damage.
Dimensions are inches (millimeters) ±0.015 (0.38) unless otherwise specified.
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit: