900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






MA-COM

AMC-182 Datasheet Preview

AMC-182 Datasheet

Cascadable Thin Film Amplifier

No Preview Available !

AM-182 / AMC-182
Cascadable Thin Film Amplifier,
28 dB Gain, 5 - 1000 MHz
Features
28.5 dB Typical Gain
2.7 dB Typical Low Noise
Description
M/A-COM’s AM-182 is a high gain feedback
amplifier with high intercept and compression points.
This amplifier is packaged in a TO-8 package. Due
to the internal power dissipation the thermal rise
should be minimized. The ground plane on the PC
board should be configured to remove heat from
under the package. AM-182 is ideally suited for use
where a high intercept, high reliability amplifier is
required.
TO-8-1
Rev. V4
Ordering Information
Part Number
AM-182 PIN
AMC-182 SMA
Package
TO-8-1
Connectorized
Outline Drawing: SMA Connectorized *
Absolute Maximum Ratings 1
Parameter
Max. Input Power
Vbias
Operating Temperature
Storage Temperature
Absolute Maximum
+13 dBm
+15.75 V
-5C to +85°C
-65°C to +125°C
1. Operation of this device above any one of these parameters
may cause permanent damage.
Dimensions are inches (millimeters) ±0.015 (0.38) unless otherwise specified.
1
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support




MA-COM

AMC-182 Datasheet Preview

AMC-182 Datasheet

Cascadable Thin Film Amplifier

No Preview Available !

AM-182 / AMC-182
Cascadable Thin Film Amplifier,
28 dB Gain, 5 - 1000 MHz
Electrical Specifications: 2,3 TA = -55°C to +85°C Case Temperature
Parameter
Test Conditions
Frequency Units
Min.
Gain
@+25oC
300 MHz
dB
27.2
Typ.
28.2
Rev. V4
Max.
29.2
Frequency Response
5 - 1000 MHz
dB
— ±1.2
Gain Variation with
Temperature
1 dB Compression
Output Power
5 - 1000 MHz
5 - 1000 MHz
dB
dBm
+9
— ±1.2
——
Noise Figure
5 - 1000 MHz
dB
4.5
Reverse Transmission
VSWR
5 - 1000 MHz
dB
-36 -32
5 - 1000 MHz
Ratio
2.0:1
Output IP2
Output IP3
Vbias
Ibias
Power Dissipation
Two-Tone inputs up to 0 dBm
Two-Tone inputs up to 0 dBm
Vbias = +15.0 VDC
@ +15 V Bias
5 - 1000 MHz
5 - 1000 MHz
dBm
dBm
VDC
mA
mW
+28
+18
+14.5
+15.0
44
660
+15.5
50
2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance.
3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 800 mW must be
provided in use.
2
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support


Part Number AMC-182
Description Cascadable Thin Film Amplifier
Maker MA-COM
Total Page 4 Pages
PDF Download

AMC-182 Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 AMC-180 Cascadable Thin Film Amplifier
MA-COM
2 AMC-182 Cascadable Thin Film Amplifier
MA-COM
3 AMC-183 Cascadable Thin Film Amplifier
MA-COM
4 AMC-184 Cascadable Thin Film Amplifier
MA-COM





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy