Force Sensor KM10
Nominal force ranges: 25N, 50N, 100N, 500N, 1000N
The KM10 is a membrane force sensor in ultra miniature design.
The force is transmitted via the universal ball joint (diameter 2.4mm, R4) in the centre of
The force sensor is assembled on a flat surface. The force sensor is centered on the outer
circumference, for example with 3 pins or within a 0.5 mm deep sink. The 9.8mm – 7.4mm
ring forms the sensor’s contact area. In the centre, a potting compound is visible up to a
7.4mm diameter. The inner ring is not used for centring.
To protect against lift-off, the contact area can be fixed on a flat surface with PUR lacquer.
Due to its small dimensions, a Teflon cable with an outer diameter of just 1.4mm is used.
Processing the AWG36 stranded wires requires a special tool (scalpel, Hoffmann stripper-
AWG36-26). The Teflon coating is intended exclusively for fixed installation, not for mobile
A version with a central cable outlet is available as an alternative to a lateral cable outlet.
Cable type in this version is STC-31v-4RWBG, PVC, Diameter 2,2mm;
collateral cabel outlet
central cabel outlet
ME-Meßsysteme GmbH, Neuendorfstr. 18a, DE-16761 Hennigsdorf
Tel +49 (0)3302 78620 60, Fax +49 (0)3302 78620 69, email@example.com, www.me-systeme.de