Datasheet4U Logo Datasheet4U.com

MP5000SDQ - 5A Programmable Current Limit Switch

This page provides the datasheet information for the MP5000SDQ, a member of the MP5000S 5A Programmable Current Limit Switch family.

Description

O transients on input (VCC).

source.

D slew rate at the source.

Features

  • Integrated 40mΩ Power FET.
  • Enable/Fault Pin.
  • Adjustable Slew Rate for Output Voltage.
  • Adjustable Current Limit: 1-5A.
  • Thermal Protection.
  • Over Voltage Limit.

📥 Download Datasheet

Datasheet preview – MP5000SDQ

Datasheet Details

Part number MP5000SDQ
Manufacturer MPS
File Size 1.19 MB
Description 5A Programmable Current Limit Switch
Datasheet download datasheet MP5000SDQ Datasheet
Additional preview pages of the MP5000SDQ datasheet.

📁 Similar Datasheet

  • MP5005 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP5005 - PRESS-FIT MOTOLOLA DIODES (Shunye)
  • MP5005W - Single Phase Bridge Rectifier (MCC)
  • MP5006 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP5007 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP5008 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP5009 - 50 Amp Single Phase Bridge Rectifier (Micro Commercial Components)
  • MP500B - Low Cost Quartz Crystal (CTS)
  • MP500B-E - Low Cost Quartz Crystal (CTS)
  • MP501 - PRESS-FIT MOTOLOLA DIODES (Shunye)
Other Datasheets by MPS
  • MP5000SDQ - 5A Programmable Current Limit Switch
  • MP5000S - 5A Programmable Current Limit Switch
  • MP5000 - 5A Programmable Current Limit Switch
  • MP5000A - 5A Programmable Current Limit Switch
  • MP5000ADQ - 5A Programmable Current Limit Switch
  • MP5000DQ - 5A Programmable Current Limit Switch
  • MP5001 - 5V Programmable Current Limit Switch
  • MP5002 - 1A-3A Programmable Current Limit Switch

Full PDF Text Transcription

Click to expand full text
MP5000S 12V, 5A Programmable Current Limit Switch R DESCRIPTION The MP5000S is a protection device designed to protect circuitry on the output (source) from O transients on input (VCC). It also protects VCC from F undesired shorts and transients coming from the source. At start up, inrush current is limited by limiting the D slew rate at the source. The slew rate is controlled by a small capacitor at the dv/dt pin. E The dv/dt pin has an internal circuit that allows the customer to float this pin (no connect) and D still receive 0.9ms ramp time at the source. S A The maximum load at the output (source) is EN N 4 current limited. This is accomplished by utilizing a sense FET topology.
Published: |