Datasheet4U Logo Datasheet4U.com

MP5016H - Current Limit Switch

Description

The MP5016H is a protection device designed to protect circuitry on the output from transients on the input.

The MP5016H also protects the input from undesired shorts and transients coming from the output.

During start-up, the inrush current is limited by limiting the slew rate at the output.

Features

  • Wide 2.7V to 22V Operating Input Range.
  • 26V Absolute Maximum Transient Input Voltage.
  • Selectable Over-Voltage Clamp Threshold.
  • Fast Output Over-Voltage Protection (OVP) Response.
  • Integrated 43mΩ Power MOSFET.
  • Adjustable Current Limit or Fixed Current Limit when Floating ILIMIT.
  • Reverse-Blocking MOSFET Driver.
  • Soft-Start Time Programmable through DV/DT and MODE.
  • Fast Response for Hard Short Protection.
  • Over-Current Protection (OCP) Hiccup Protect.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MP501 PRESS-FIT MOTOLOLA DIODES Shunye
MP5010 50 Amp Single Phase Bridge Rectifier Micro Commercial Components
MP5010M High Current Glass Passivated Molding Single-Phase Bridge Rectifier Leshan Radio Company
MP5010W Single Phase Bridge Rectifier MCC
MP501M High Current Glass Passivated Molding Single-Phase Bridge Rectifier Leshan Radio Company

Other Datasheets by Monolithic Power Systems

Part Number Description
MP5016 Current Limit Switch
MP5010 Programmable Current Limit Switch
MP5010DQ Programmable Current Limit Switch
MP5013A 5A Programmable Current-Limit Switch
MP5013E Programmable Current-Limit Switch

Full PDF Text Transcription

Click to expand full text
MP5016H 2.7 - 22V, 0.7 - 5A, Current Limit Switch with Over-Voltage Clamp and Reverse Block The Future of Analog IC Technology DESCRIPTION The MP5016H is a protection device designed to protect circuitry on the output from transients on the input. The MP5016H also protects the input from undesired shorts and transients coming from the output. During start-up, the inrush current is limited by limiting the slew rate at the output. The slew rate is controlled by the DV/DT pin setting and MODE pin setting. The maximum load at the output is currentlimited. The magnitude of the current limit is controlled by an external resistor from ILIMIT to GND. There is a fixed 2.5A current limit when ILIMIT is floating. The output voltage is limited by the output overvoltage protection (OVP) function.
Published: |