Datasheet4U Logo Datasheet4U.com

MP5036 - Current Limit Switch

General Description

The MP5036 is a protection device designed to protect circuitry on the output from transients on the input.

It also protects the input from undesired shorts and transients coming from the output.

During start-up, the inrush current is limited by limiting the slew rate at the output.

Key Features

  • Wide 2.9V to 14V Continued Operating Input Range.
  • 26V Absolute Maximum Transient Input Voltage.
  • Fixed 15V Over-Voltage Clamp Threshold.
  • Fast Output OVP Response.
  • Integrated 43mΩ Power FET.
  • Adjustable Current Limit or Fixed Current Limit when floating ILIMIT pin.
  • Soft Start Time Programmable through the DV/DT Pin.
  • Fast Response for Hard Short Protection.
  • OCP Hiccup Protection.
  • Thermal Shutdown and Auto Retry.
  • Available in TSOT23-6 Package AP.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MP503 Air-Quality Gas Sensor Winsen
MP503 PRESS-FIT MOTOLOLA DIODES Shunye
MP5005 50 Amp Single Phase Bridge Rectifier Micro Commercial Components
MP5005 PRESS-FIT MOTOLOLA DIODES Shunye
MP5005W Single Phase Bridge Rectifier MCC

Other Datasheets by Monolithic Power Systems

Part Number Description
MP5036A 0.4A to 5A Current Limit Switch
MP5036AGJ 0.4A to 5A Current Limit Switch
MP5036GJ Current Limit Switch
MP5031 USB PD Port Controller
MP5032 QC 3.0 Controller

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
MP5036 12V, 0.4A to 5A, Current Limit Switch with 15V Over-Voltage Clamp in TSOT23 Package DESCRIPTION The MP5036 is a protection device designed to protect circuitry on the output from transients on the input. It also protects the input from undesired shorts and transients coming from the output. During start-up, the inrush current is limited by limiting the slew rate at the output. The slew rate is controlled by the DV/DT pin setting. The maximum load at the output is currentlimited. The magnitude of the current limit is controlled by an external resistor from ILIMIT to GND. There is a fixed 2.5A current limit when floating the ILIMIT pin. The output voltage is limited by the output overvoltage protection (OVP) function. The device is available in a TSOT23-6 package.