MT7202 - 1.5A LED driver

Description

The MT7202 is a continuous mode inductive step-down converter, designed for driving single or multiple series connected LEDs efficiently from a voltage source higher than the LED voltage.

Maxic Technology

📥 Download Datasheet

Datasheet Details

Part number	MT7202
Manufacturer	Maxic Technology
File Size	432.64 KB
Description	1.5A LED driver
Datasheet	MT7202 Datasheet

📁 Similar Datasheet

MT7203 - (MT7103 - MT7403) 3mm Ultra Bright Red LED (Marktech)
MT72038 - FOUR CHANNEL ARINC 429 LINE RECEIVER (Aeroflex Circuit Technology)
MT72HTS1G72FZ - DDR2 SDRAM FBDIMM (Micron)
MT72HVQ1G72PY-53E - DDR2 SDRAM VLP RDIMM (Micron Technology)
MT72HVQ1G72PY-667 - DDR2 SDRAM VLP RDIMM (Micron Technology)
MT72JSZS4G72LZ - DDR3 SDRAM LRDIMM (Micron)
MT72KSZS2G72LZ - DDR3L 1.35V SDRAM LRDIMM (Micron Technology)
MT72KSZS2G72LZ-1G1 - DDR3L 1.35V SDRAM LRDIMM (Micron Technology)
MT72KSZS2G72LZ-1G4 - DDR3L 1.35V SDRAM LRDIMM (Micron Technology)
MT72KSZS4G72LZ - DDR3L 1.35V SDRAM LRDIMM (Micron Technology)

Other Datasheets by Maxic Technology

MT7200 - 350mA LED driver
MT7201 - 1A LED driver
MT7201C - 1A LED driver
MT7201C+ - 1A LED driver
MT7261 - Boost White LED Driver
MT7281 - High frequency PWM dimming LED constant current driver chip
MT7282 - Boost/Buck-Boost/Buck White LED Driver
MT7285 - Boost/Buck-Boost/Buck White LED Driver

Full PDF Text Transcription

Click to expand full text

MT7202 1.5A LED driver with internal switch DESCRIPTION The MT7202 is a continuous mode inductive step-down converter, designed for driving single or multiple series connected LEDs efficiently from a voltage source higher than the LED voltage. The device operates from an input supply between 6V~50V and provides an externally adjustable output current of up to 1.5A. The MT7202 includes the output switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current. Output current can be adjusted below the set value, by applying an external control signal to the 'ADJ' pin. The ADJ pin will accept either a DC voltage or a PWM waveform.

Published: Apr 21, 2018 |