Datasheet4U Logo Datasheet4U.com

DS1314 - 3V Nonvolatile Controller

Description

VCCI VCCO VBAT - Power Supply Input - SRAM Power Supply Output - Backup Battery Input CEI - Chip Enable Input CEO TOL BW - Chip Enable Output - VCC Tolerance Select - Battery Warning Output (Open Drain) RST GND NC - Reset Output (Open Drain) - Ground - No Connection DESCRIPTION The DS1314 No

Features

  • Converts CMOS SRAM into nonvolatile memory.
  • Unconditionally write-protects SRAM when VCC is out of tolerance.
  • Automatically switches to battery backup supply when VCC power failure occurs.
  • Monitors voltage of a lithium cell and provides advanced warning of impending battery failure.
  • Signals low-battery condition on active low Battery Warning output signal.
  • Automatic VCC power-fail detection for 3.0V or 3.3V power supplies.
  • Space-saving 8-pin DIP and SOIC packa.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
DS1314 3V Nonvolatile Controller ART CHIP
DS1300-3 AC-DC / Distributed Power Front-End 2U Emerson
DS1302 Trickle Charge Timekeeping Chip TGS
DS1307 64 X 8 Serial Real Time Clock TGS
DS1307 Real-Time Clock Maxim

Other Datasheets by Maxim Integrated (Analog Devices)

Part Number Description
DS1312 Nonvolatile Controller
DS1315 Phantom Time
DS1318 Parallel-Interface Elapsed Time Counter
DS1302 Trickle-Charge Timekeeping Chip
DS1305 Serial Alarm Real-Time Clock

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
19-6307; Rev 6/12 DS1314 3V Nonvolatile Controller with Lithium Battery Monitor FEATURES  Converts CMOS SRAM into nonvolatile memory  Unconditionally write-protects SRAM when VCC is out of tolerance  Automatically switches to battery backup supply when VCC power failure occurs  Monitors voltage of a lithium cell and provides advanced warning of impending battery failure  Signals low-battery condition on active low Battery Warning output signal  Automatic VCC power-fail detection for 3.0V or 3.
Published: |