Datasheet4U Logo Datasheet4U.com

MAX13450E - RS-485 Transceivers

General Description

The MAX13450E/MAX13451E are half-duplex and fullduplex RS-485/RS-422 transceivers.

These devices feature internal 100I and 120I termination resistors.

The resistor values are pin selectable.

Key Features

  • a logic inversion function. The logic inversion allows phase reversal of the A-B signals in case these are inadvertently connected wrongly. The MAX13450E/MAX13451E have 1/8-unit load receiver input impedance, allowing up to 256 transceivers on the bus. All driver outputs are protected to Q30kV ESD using the Human Body Model (HBM). The MAX13450E/MAX13451E are available in a 14-pin TSSOP package and operate over the automotive -40NC to +125NC temperature range. Resistors S Driver Drives 100I Doub.

📥 Download Datasheet

More Datasheets from Maxim Integrated (now Analog Devices)

Part Number Description
MAX13451E RS-485 Transceivers
MAX13430E RS-485 Transceivers
MAX13431E RS-485 Transceivers
MAX13432E RS-485 Transceivers
MAX13433E RS-485 Transceivers
MAX13442E Fail-Safe RS-485/J1708 Transceivers
MAX13443E Fail-Safe RS-485/J1708 Transceivers
MAX13444E Fail-Safe RS-485/J1708 Transceivers
MAX13448E 80V Fault-Protected Full-Duplex RS-485 Transceiver
MAX13481E (MAX13481E - MAX13483E) ESD-Protected USB Transceivers

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.DataSheet4U.com 19-5254; Rev 0; 4/10 RS-485 Transceivers with Integrated 100Ω/120Ω Termination Resistors General Description The MAX13450E/MAX13451E are half-duplex and fullduplex RS-485/RS-422 transceivers. These devices feature internal 100I and 120I termination resistors. The resistor values are pin selectable. A logic supply input allows interfacing to logic levels down to +1.8V. The MAX13450E/MAX13451E feature strong drivers specified to drive low-impedance lines found when a fully loaded bus, based on today’s 100I characteristic impedance cable, is doubly terminated. Both devices allow slew-rate limiting of the driver output to reduce EMI and reflections for data rates up to 500kbps.