24LC22A Datasheet | Microchip Technology

Features : - Single Supply with Operation Down to 2.5V - Supports Enhanced EDID™ (E-EDID™) 1.3 - pletely Implements DDC1™/DDC2™ Interface for Monitor Identification, Including Recovery to DDC1 - 2 Kbit Serial EEPROM Low-Power CMOS Technology: - 1 m A typical active current - 10 u A standby current typical at 5.5V - 2-Wire Serial Interface Bus, I2C™ patible - 100 k Hz (2.5V) and 400 k Hz (5V) patibility - Self-Timed Write Cycle (including Auto-Erase) - Page-Write Buffer for up to Eight Bytes - 1,000,000 Erase/Write Cycles - Data Retention >200 years - ESD Protection >4000V - 8-pin PDIP and SOIC Packages - Available Temperature Ranges: - Industrial (I) -40°C to +85°C - Pb-Free and Ro HS pliant Description : The Microchip Technology Inc. 24LC22A is a 256 x 8bit dual-mode Electrically Erasable PROM. This device is designed for use in applications requiring storage and serial transmission of configuration and control information. Two modes of operation have been implemented: Transmit-Only mode (1 Kbit) and Bidirectional mode (2 Kbit). Upon power-up, the device will be in the Transmit-Only mode, sending a serial bit stream of the memory array from 00h to 7Fh, clocked by the VCLK pin. A valid high-to-low transition on the SCL pin will cause the device to enter the Transition mode, and look for a valid control byte on the I2C bus. If it detects a valid control byte from the master, it will switch into Bidirectional mode, with byte selectable read/write capability of the entire 2K memory array using SCL. If no control byte is received, the device will revert to the Transmit-Only mode after it receives 128 consecutive VCLK pulses while the SCL pin is idle. The 24LC22A is available in standard 8-pin PDIP and SOIC packages. Package Types PDIP/SOIC - NC 1 - NC 2 - NC 3 VSS 4 8 VCC 7 VCLK 6 SCL 5 SDA - Pins labeled ‘NC’ has no internal connections Block Diagram I/O Control Logic Memory Control Logic XDEC SDA SCL VCLK VCC VSS HV Generator EEPROM Array Page...