Datasheet4U Logo Datasheet4U.com

ME2206 - 3W High Power White LED

Description

The ME2206 is a set-up DC-DC converter that delivers a regulated output current.

The device switches at a 1MHz constant frequency,allowing for the use of small value external inductor and ceramic capacitors.

Features

  • l l l l l l l l l l l LED Power Efficiency: up to 90% Current Accuracy: ±10% Low Start-Up Voltage: 0.9V(ILEDÿ270m A) Low Hold Voltage:0.75V(ILEDÿ200m A) 1MHz Switching Frequency Uses small, Low Profile External Components Low RDS(ON) : 100mΩ (TYP. ) Open LED Protection Over Temperature Protection Low Profile SOT-23-6 Package Pb-Free Package.

📥 Download Datasheet

Datasheet preview – ME2206

Datasheet Details

Part number ME2206
Manufacturer Microne
File Size 344.24 KB
Description 3W High Power White LED
Datasheet download datasheet ME2206 Datasheet
Additional preview pages of the ME2206 datasheet.

📁 Similar Datasheet

  • ME2-CH2O-16x15 - Electrochemical Formaldehyde Sensor (Winsen)
  • ME2-CH2O-D16 - Electrochemical Formaldehyde Sensor (Winsen)
  • ME2-CO-D14-C - Electrochemical Carbon Monoxide sensor (Winsen)
  • ME2-O2-D20 - Electrochemical Oxygen Sensor (Winsen)
  • ME200N04T - N-Channel MOSFET (Matsuki)
  • ME200N04T-G - N-Channel MOSFET (Matsuki)
  • ME20N03 - N-Channel Enhancement MOSFET (Matsuki)
  • ME20N10 - N-Channel 100V (D-S) MOSFET (Matsuki)
  • ME20N10-G - N-Channel 100V (D-S) MOSFET (Matsuki)
  • ME20N15 - N-Channel MOSFET (Matsuki)
Other Datasheets by Microne

Full PDF Text Transcription

Click to expand full text
3W High Power White LED ME2206 Ver04 3W High Power White LED ME2206 General Descriptionÿ The ME2206 is a set-up DC-DC converter that delivers a regulated output current. The device switches at a 1MHz constant frequency,allowing for the use of small value external inductor and ceramic capacitors. The ME2206 is targeted to be used for driving loads up to 1A from a two-cell alkaline battery. The LED current can be programmed by the external current sense resistor, Rs, connected between the feedback pin (FB) and ground. A low 95mV feedback voltage reduces the power loss in the Rs for better efficiency. During the shutdown mode, the feedback resistor Rs and the load are completely disconnected and the current consumption is reduced to less than 1uA.
Published: |