900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf




Motorola Electronic Components Datasheet

MC54HC4016A Datasheet

Quad Analog Switch/ Multiplexer/Demultiplexer

No Preview Available !

MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
Pwrwowd.DuatcaSthePetr4eU.vcoimew
MC54/74HC4016A
Quad Analog Switch/
Multiplexer/Demultiplexer
High–Performance Silicon–Gate CMOS
The MC54/74HC4016A utilizes silicon–gate CMOS technology to
achieve fast propagation delays, low ON resistances, and low OFF–
channel leakage current. This bilateral switch/multiplexer/demultiplexer
controls analog and digital voltages that may vary across the full
power–supply range (from VCC to GND).
The HC4016A is identical in pinout to the metal–gate CMOS MC14016
and MC14066. Each device has four independent switches. The device
has been designed so that the ON resistances (RON) are much more
linear over input voltage than RON of metal–gate CMOS analog switches.
This device is identical in both function and pinout to the HC4066A. The
ON/OFF Control inputs are compatible with standard CMOS outputs; with
pullup resistors, they are compatible with LSTTL outputs. For analog
switches with voltage–level translators, see the HC4316A. For analog
switches with lower RON characteristics, use the HC4066A.
Fast Switching and Propagation Speeds
High ON/OFF Output Voltage Ratio
Low Crosstalk Between Switches
Diode Protection on All Inputs/Outputs
Wide Power–Supply Voltage Range (VCC – GND) = 2.0 to 12.0 Volts
Analog Input Voltage Range (VCC – GND) = 2.0 to 12.0 Volts
Improved Linearity and Lower ON Resistance over Input Voltage than
the MC14016 or MC14066
Low Noise
Chip Complexity: 32 FETs or 8 Equivalent Gates
LOGIC DIAGRAM
XA 1
A ON/OFF CONTROL 13
2 YA
XB 4
3 YB
B ON/OFF CONTROL 5
XC 8
C ON/OFF CONTROL 6
9 YC
ANALOG
OUTPUTS/INPUTS
XD 11
10 YD
D ON/OFF CONTROL 12
ANALOG INPUTS/OUTPUTS = XA, XB, XC, XD
PIN 14 = VCC
PIN 7 = GND
14
1
J SUFFIX
CERAMIC PACKAGE
CASE 632–08
14
1
14
1
N SUFFIX
PLASTIC PACKAGE
CASE 646–06
D SUFFIX
SOIC PACKAGE
CASE 751A–03
14
1
DT SUFFIX
TSSOP PACKAGE
CASE 948G–01
ORDERING INFORMATION
MC54HCXXXXAJ
MC74HCXXXXAN
MC74HCXXXXAD
MC74HCXXXXADT
Ceramic
Plastic
SOIC
TSSOP
PIN ASSIGNMENT
XA
YA
YB
XB
B ON/OFF
CONTROL
C ON/OFF
CONTROL
GND
1
2
3
4
5
6
7
14 VCC
13
A ON/OFF
CONTROL
12 D ON/OFF
CONTROL
11 XD
10 YD
9 YC
8 XC
FUNCTION TABLE
On/Off Control
Input
L
H
State of
Analog Switch
Off
On
This document contains information on a product under development. Motorola reserves the right to change or discontinue this product without notice.
10/95
© Motorola, Inc. 1995
3–1 REV 0


Motorola Electronic Components Datasheet

MC54HC4016A Datasheet

Quad Analog Switch/ Multiplexer/Demultiplexer

No Preview Available !

ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎMC54/74HC4016A
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎMAXIMUM RATINGS*
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎSwywmwb.DolataSheet4U.com
Parameter
Value
Unit
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎVCC
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎVIS
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎVin
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎI
Positive DC Supply Voltage (Referenced to GND)
Analog Input Voltage (Referenced to GND)
Digital Input Voltage (Referenced to GND)
DC Current Into or Out of Any Pin
– 0.5 to + 14.0
– 0.5 to VCC + 0.5
– 0.5 to VCC + 0.5
± 25
V
V
V
mA
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎPD Power Dissipation in Still Air,Plastic or Ceramic DIP†
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎSOIC Package†
TSSOP Package†
750
500
450
mW
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎTstg Storage Temperature
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎTL Lead Temperature, 1 mm from Case for 10 Seconds
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎ(Plastic DIP, SOIC or TSSOP Package)
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎ(Ceramic DIP)
– 65 to + 150
260
300
_C
_C
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎ* Maximum Ratings are those values beyond which damage to the device may occur.
This device contains protection
circuitry to guard against damage
due to high static voltages or electric
fields. However, precautions must
be taken to avoid applications of any
voltage higher than maximum rated
voltages to this high–impedance cir-
cuit. For proper operation, Vin and
v vVout should be constrained to the
range GND (Vin or Vout) VCC.
Unused inputs must always be
tied to an appropriate logic voltage
level (e.g., either GND or VCC).
Unused outputs must be left open.
I/O pins must be connected to a
properly terminated line or bus.
Functional operation should be restricted to the Recommended Operating Conditions.
†Derating — Plastic DIP: – 10 mW/_ C from 65_ to 125_ C
Ceramic DIP: – 10 mW/_ C from 100_ to 125_ C
SOIC Package: – 7 mW/_ C from 65_ to 125_ C
TSSOP Package: – 6.1 mW/_ C from 65_ to 125_ C
For high frequency or heavy load considerations, see Chapter 2 of the Motorola High–Speed CMOS Data Book (DL129/D).
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎRECOMMENDED OPERATING CONDITIONS
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎSymbol
Parameter
Min Max Unit
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎVCC Positive DC Supply Voltage (Referenced to GND)
2.0 12.0 V
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎVIS Analog Input Voltage (Referenced to GND)
GND VCC V
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎVin Digital Input Voltage (Referenced to GND)
GND VCC V
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎVIO* Static or Dynamic Voltage Across Switch
— 1.2 V
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎTA Operating Temperature, All Package Types
– 55 + 125 _ C
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎtr, tf Input Rise and Fall Time, ON/OFF
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎControl Inputs (Figure 10)
VCC = 2.0 V
VCC = 3.0 V
VCC = 4.5 V
VCC = 9.0 V
VCC = 12.0 V
0
0
0
0
0
1000
600
500
400
250
ns
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎ* For voltage drops across the switch greater than 1.2 V (switch on), excessive VCC current may
be drawn; i.e., the current out of the switch may contain both VCC and switch input components.
The reliability of the device will be unaffected unless the Maximum Ratings are exceeded.
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎDC ELECTRICAL CHARACTERISTICS Digital Section (Voltages Referenced to GND)
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎSymbol
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎVIH
Parameter
Minimum High–Level Voltage
ON/OFF Control Inputs
Test Conditions
Ron = per spec
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎVIL MaximumLow–LevelVoltage
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎON/OFF Control Inputs
Ron = per spec
VCC
V
2.0
3.0
4.5
9.0
12.0
2.0
3.0
4.5
9.0
12.0
Guaranteed Limit
– 55 to
25_ C
v 85_C v 125_C
1.5 1.5 1.5
2.1 2.1 2.1
3.15 3.15 3.15
6.3 6.3 6.3
8.4 8.4 8.4
0.5 0.5 0.5
0.9 0.9 0.9
1.35 1.35 1.35
2.70 2.70 2.70
3.6 3.6 3.6
Unit
V
V
MOTOROLA
3–2 High–Speed CMOS Logic Data
DL129 — Rev 6


Part Number MC54HC4016A
Description Quad Analog Switch/ Multiplexer/Demultiplexer
Maker Motorola
Total Page 12 Pages
PDF Download

MC54HC4016A Datasheet PDF

View PDF for Mobile








Similar Datasheet

1 MC54HC4016 Quad Analog Switch/Multiplexer/Demultiplexer
Motorola
2 MC54HC4016 Quad Analog Switch/ Multiplexer/Demultiplexer
ON Semiconductor
3 MC54HC4016A Quad Analog Switch/ Multiplexer/Demultiplexer
Motorola





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy