Noise Suppression Products/EMI Suppression Filters > Common Mode Choke Coil > Wire Wound Type for Large Current
Continued from the preceding page.
c Derating of Rated Current
In operating temperature exceeding +60°C,
derating of current is necessary for the
following part name of DLW5BT series.
Please apply the derating curve shown in
chart according to the operating
Derating of Rated Current
0 20 40 60 80 100
Operating Temperature (°C)
Do not use products beyond the rated current and
rated voltage as this may create excessive heat
and deteriorate the insulation resistance.
Solderability of Tin plating termination chip might be
deteriorated when low temperature soldering proﬁle
where peak solder temperature is below the Tin melting
point is used. Please conﬁrm the solderability of Tin
plating termination chip before use.
oThis data sheet is applied for CHIP COMMON MODE CHOKE COIL used for General Electronics equipment for your design.
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s speciﬁcations are subject to change or our
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical speciﬁcations because there is no space for detailed speciﬁcations. Therefore, please approve our product
speciﬁcations or transact the approval sheet for product speciﬁcations before ordering.
Free Datasheet http://www.Datasheet4U.com