Datasheet4U Logo Datasheet4U.com

LM311B - Voltage comparator

Description

The LM111 series are voltage comparators that have input currents approximately a hundred times lower than devices like the µA710.

They are designed to operate over a wider range of supply voltages; from standard ±15V op amp supplies down to a single 3V supply.

Features

  • Operates from single 3V supply (LM311B).
  • Maximum input bias current: 150nA (LM311.
  • 250nA).
  • Maximum offset current: 20nA (LM311.
  • 50nA).
  • Differential input voltage range: ±30V.
  • Power consumption: 135mW at ±15V.
  • High sensitivity.
  • 200V/mV.
  • Zero crossing detector.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
LM311 Single Comparator Fairchild Semiconductor
LM311 Voltage Comparator National Semiconductor
LM311 Voltage comparator STMicroelectronics
LM311 Single Comparators ON Semiconductor
LM311 Differential Comparators Texas Instruments

Other Datasheets by NXP Semiconductors

Part Number Description
LM319 Dual voltage comparator
LM324A Low power Quad OpAmp
LM339 Quad voltage comparator
LM339A Quad voltage comparator
LM358D Low Power Dual Operational Amplifier

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
Philips Semiconductors Linear Products Product specification Voltage comparator LM111/211/311/ LM311B DESCRIPTION The LM111 series are voltage comparators that have input currents approximately a hundred times lower than devices like the µA710. They are designed to operate over a wider range of supply voltages; from standard ±15V op amp supplies down to a single 3V supply. Their output is compatible with RTL, DTL, and TTL as well as MOS circuits. Further, they can drive lamps or relays, switching voltages up to 50V at currents as high as 50mA. Both the inputs and the outputs of the LM111 series can be isolated from system ground, and the output can drive loads referred to ground, the positive supply, or the negative supply.
Published: |