MC56F83683 Datasheet | NXP Semiconductors

Features - This family of digital signal controllers (DSCs) is based on the 32-bit 56800EX core. On a single chip, each device bines the processing power of a DSP and the functionality of an MCU, with a flexible set of peripherals to support many target applications: - Industrial control - Home appliances - General-purpose inverters - Smart sensors, fire and security systems - Switched-mode power supply and power management - Power distribution systems - Motor control (ACIM, BLDC, PMSM, SR, stepper) - Uninterruptible power supplies (UPS) - Solar inverter - Medical monitoring applications - DSC based on 32-bit 56800EX core - Up to 100 MIPS at 100 MHz core frequency - DSP and MCU functionality in a unified, C-efficient architecture - On-chip memory - Up to 2×128 KB dual partition flash memory with ECC protection - Up to 64 KB data/program RAM - Both on-chip flash memory and RAM can be mapped into both program and data memory spaces - 32 KB boot ROM supports boot from SCI, I2C and CAN - Analog - Two high-speed, 8-ch external and 2-ch internal, 12bit ADCs with dynamic x1, x2, and x4 programmable amplifier - Four analog parators with integrated 8-bit DAC references - Two standard Flex PWM modules with up to 2x8 PWM outputs Document Number MC56F836XXDS Rev. 1.6, 09/2019 MC56F836XXDS - munication interfaces - Up to three high-speed queued SCI (QSCI) modules with LIN slave functionality - Up to two queued SPI (QSPI) modules - Two I2C/SMBus ports - One Flex CAN module, with Flexible Data-rate (CAN-FD) supported - One USB2.0 controller with integrated PHY - Timers - Two 16-bit quad timer (2 x 4 16-bit timer) - Two Periodic Interval Timers (PITs) - Security and integrity - Cyclic Redundancy Check (CRC) generator - Windowed puter operating properly (COP) watchdog - External Watchdog Monitor (EWM) -...