MC9S08SE4 Datasheet | NXP Semiconductors

Features 8-Bit HCS08 Central Processor Unit (CPU) - 20 MHz HCS08 CPU (central processor unit) - 10 MHz internal bus frequency - HC08 instruction set with added BGND - Support for up to 32 interrupt/reset sources On-Chip Memory - Up to 8 KB of on-chip in-circuit programmable flash memory with block protection and security options - Up to 512 bytes of on-chip RAM Power-Saving Modes Clock Source Options - Oscillator (XOSC) - Loop-control Pierce oscillator; crystal or ceramic resonator range of 31.25 k Hz to 38.4 k Hz or 1 MHz to 16 MHz - Internal Clock Source (ICS) - Internal clock source module containing a frequency-locked-loop (FLL) controlled by internal or external reference; precision trimming of internal reference allows 0.2% resolution and 2% deviation over temperature and voltage; supports bus frequencies from 1 MHz to 10 MHz. System Protection - Optional puter operating properly (COP) reset with option to run from independent 1 k Hz internal clock source or the bus clock Development Support - Single-wire background debug interface Peripherals - SCI - Full duplex non-return to zero (NRZ); LIN master extended break generation; LIN slave extended break detection; wakeup on active edge - ADC - 10-channel, 10-bit resolution; 2.5 μs conversion time; automatic pare function; 1.7 m V/°C temperature sensor; internal bandgap reference channel; runs in stop3 - TPMx - One 2-channel (TPM1) and one 1-channel (TPM2) 16-bit timer/pulse-width modulator (TPM) modules; selectable input capture, output pare, and edge-aligned PWM capability on each channel; timer module may be configured for buffered, centered PWM (CPWM) on all channels - KBI - 8-pin keyboard interrupt module - RTC - Real-time counter with binary- or decimal-based prescaler Input/Output - Software selectable pullups on ports when used as inputs - Software selectable slew rate control on ports when used as outputs - Software selectable drive strength on ports when used as outputs - Master reset pin and power-on...